Q&A

1994 Ford Ranger

Question: replacing temperature sensor for a 94 Ford Ranger

Question

GGJJJ, Elmwood Park, IL, April 15, 2009, 15:18

 Rookie

replacing temperature sensor for a 94 Ford Ranger

2 Answers

Answer It

Flag This

Follow this Question Unfollow this Question

• Answer #1

  irvtech April 28, 2009, 01:50
  

   Journeyman

  What motor? Which temperature sensor, for the gauge or for the engine control system?Four cylinder motors have the sensor around the intake manifold on the driver's side of the motor. The V-6 it is around the rear of the motor.
  Flag This
  Like | 1 person likes this1
• Reply

  kentakakura, October 30, 2010, 06:30
  

   Rookie

  for the guage....where is it located? Is it the 2 wire switch mounted in-line of the heater hose?
  Reply
  Flag This
• Answer #2

  eberrios December 02, 2009, 05:20
  

   Rookie

  replace heater coil
  Flag This
  Like | 1 person likes this1
• Reply

  eberrios, December 02, 2009, 05:28
  

   Rookie

  4 cyl 2.3 rear drive.heating system works verry poor. is it the heating coil.i changed thermostad and cooling but dont get warm just a litter 1 hour later. thanks
  Reply
  Flag This

• Why does my truck idle fine when cold, yet rough when warmed up.
  I purchased a 2000 Ford Ranger XLT, 4WD with 94,000 miles from a local used car lot. Two days after taking possesion of the vehicle the check engine light came on. I took the vehicle back, and thie...

  Q&A > Ford > 1990 Ford Ranger