Replacing battery on 2004 Chrysler 300M

How do I remove the housing for the air filter so I can replace my battery?

by in San Antonio, TX on August 25, 2010
1 answer
ANSWER by on August 31, 2010
The battery is accessible without removing the right front wheel and tire assembly.. Verify that the ignition switch and all accessories are OFF. Turn the steering wheel to the full right position. Disconnect and isolate the negative battery cable remote terminal from the remote battery post. WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS. Remove the air cleaner housing. (the housing is held in by rubber grommets) Remove battery splash shield.. Disconnect the heater blanket cord, if equipped. Remove the two short bolts from the battery hold down and remove the hold down. Disconnect the positive battery cable from the battery. Slide the battery toward rear of vehicle. Disconnect the negative battery cable from the battery. Remove battery from vehicle.
Related Items:
battery dies if car is not run every day. replaced battery twice, checked all lights (trunk, glove depart. etc)had in shop three times (found nothing)! also head lights flash randomly while switch ...
i have cleaned all connections and even replaced the battery but i cannot get the dash warning light to go off.. am i missing something or is there a different battery that i dont know about???? ...
Replaced my battery cables my battery and my starter but my engine light came on but no codes when I do the key dance....please help me
Is there an easier way to replace headlamp bulbs? Please let me know. Thanks

Related Content