replaceing axle on 2006 Dodge Ram 2500

how do i take out the front axle driver side

by in Eureka, CA on September 11, 2009
2 answers 2 comments
ANSWER by on September 11, 2009
Open the half shaft nut where it protrudes through the outer spindle/hub assembly, remove the caliper and rotor, remove the four bolts at the back of the steering knuckle/hub that retain the bearing in the hub. Axle nut torque is 132 ft/lb.The axle will be able to be with drawn from the front differential once the outer portion of the hub is disassembled.
COMMENT by on September 11, 2009
remove front axle
COMMENT by on December 01, 2010
wat if i dont have a torque wrinch
ANSWER by on February 08, 2011
pull tire then brAKE CALIPER. SLIDE ROATER OFF OF HUB ASEMBLY TAKE 4 BOLTS OUT OF BACK OF HUB ASSEMBLY. UNHHOK WHEEL SPEED SENSOR AT JUNCTION WICH IS BEHIND WHEELWELL AND SLIP AXLE OUT. EASY AS HELL
Related Items:
how do i pull the front axle out
I have a 1998 ram 2500 the speedometer doesn't work until the truck hits 25 mph and the abs and brake light are on I've been told by two different dodge mechanics, that it is my speed sensor, when ...
ocaasionally it will shift on it own but most of the time I had to put it into neutral then back into drive..i replaced the speed sensor and the abs sensor on the rear axle still no change , then i...
i have a 2005 dodge ram 2500 i broke the spider gears in the front axle i did not have the money to fix it at the time but i do now and need to get it done with the bad weather coming....so i pulle...
im needing to replace the driver side axle seal. how long ca n i drive it before i replace it . it is leaking grease.

Related Content