removal of #3 spark plug on 2000 Chevrolet Blazer

How do you remove #3 spark plug when the steering shaft is right in front of it.

by in Pontiac, MI on May 04, 2010
2 answers
ANSWER by on May 05, 2010
There is a company that independent auto repair shops "buy" their information from that offer a very reasonable service to do it yourselvers. You can get a one week subscription or year subscription very cheap. The information is year make and model specific repair procedures, service bulletins, component locations, wiring diagrams ect.... great quality information same as the professionals have ,much better than generic workshop manuals from parts stores, much cheaper than the factory manual try and get an online repair manual subscription.
ANSWER by on December 01, 2010
not fun, but with practice you can do it. Because socket wrenches are too fat you have to use a spark plug socket that has a hex wrench end on it (most already do), use a box end or combo wrench to turn it. Those can slip into that tight spot.
Related Items:
how do you find top dead center to set the timing on a 4.3 v-6
When starting in the morning, it starts fine but after a minute or two the odd sputter will happen, then become more frequent, about every 30 seconds or so. After letting it warm up for about 5 mi...
I have a 2001 chevy s10 blazer 2 wheel drive with the 4.3 vortec. I need to replace the coolant temp sensor. Where is this located? Thank you

Related Content