Mitsubishi Endeavor Questions
Answered Mitsubishi Endeavor Questions
Ask a Question
I did change the mass air flow sensor and both up stream O2 sensors and the light is still on
my 2006 ME does not change speed, I think may it has some electrical transmission problem or sensor. i need help from someone who knows.
drove truck in. changed pulleys and timing belt. all timing marks are exact. engine cranks but no start. code 0335. changed sensor. same. 12v on red. good gnd.4.9 on sig. rpms show 130. sig v. fluctuate when cranking. no other codes. where do I go now?
did have a traction control light coming on before this. approx. 140,000 miles. first work of any kind on vehicle. all literature I am able to get is limited info.
I have no wiring diagram need to know what the fuse powers up
Some days it happens only occasionally some days every time its driven.
Everything on the stereo is working but the volume, no noise will come out no matter what the volume is set at.
I changed my catalyst both of them with new gaskets and o2 sensors replaced coil pack on 4th cylinder because it misfired corrected that issue changed valve gaskets were leaking new spark plugs put in move working sp...
the window won't roll up or down from the main switch on drivers side for that window. put in new switch and power window regulator and motor assembly. still only rolls down, not up...help
Problems with electrical...can't roll down windows, can't open rear hatch, radio powers up but won't play, occasionally won't start. Battery is good.
Just started yesterday morning when I noticed the SRS light is steady on for the duration of the trip.(a short errand about 20 minutes). Same thing happened today. Please advise. Thanks
Something is lodged in there and we need to get to the fan, how do we do that
it struggles to crank then when it does it will go dead
Using the same wiring harness from 06.
It will only turn to ACC and will not turn to lock to pull it out. I've had the truck since 2003 and this is the first time this has happened.
My air conditioner is leaking water on the passager side every time I ran the air
popping sound similar to when a battery had died. I happened to be in front of a repair shop so I asked for a jump. The car's electrical system is totally off, no lights, no door lock, no windows, no dash lights. This...
Sunroof the back of it drops down and the front stays up. It doesnt seal properly. If tried adjusting the screws they wont stay in. I googled it it says I need new screws that are longer and a spacer. But I cant find ...
Changed spark plugs ands timing belt. Now isle is low and hesitated before acceleration.
Service engine soon light is on
The sensor was clean. Where is the connector located? I want to test the sensor for resistance and replace if needed? Where is the ABS module located?
My 2008 Endeavor has a noisy suspension with a lot of thump and noise into the cabin. Is this normal for this vehicle or is there something wrong I need to take care of? There also appears to be something loose that ...
I have found and removed 1 bolt, but cannot find the 2nd one. Also does the 2nd use the same size socket?
14,000 miles. Bought a year ago with 5 miles on it. It was a left over. This morning (30 degree) when I started it the motor was knocking very loud! I shut it off. I started it again and it was not as loud and shut it...