Mercury Capri Questions
All Mercury Capri Questions
Ask a Question
im using an impact wrench, still cant get puller off
motor is good. feels like cable is off lower plastic wheel. it may have a rough spot in it. what would i have to do to put cable back on wheel or replace cable. thank you
The car idles fine, runs well on level ground at constant speed, but when I need more acceleration, such as going up a hill or accelerating quickly, it shudders and lurches forward, and I can't get enough power. One ...
My automatic windows will not roll back up. I think I popped a fuse. is this an easy fix? what amp or voltage do I need? any advise? thanks.
Have a check engine light but cant find the datat port. Ive read that its on the fire wall in the engine compartment but cant find an OBD 1 plug. Any other way to check for the code and clear it? Thanks
There is more than 2 wires
If memory serves me right they said it was the hydro carbons and that it barely failed. They told me to add a fuel additive and bring it back but it didn't pass again but it was closer. The car had been sitting in a...
91 mercury capri starts and idles smooth but spontaneously dies while driving. Could these be a tranny sensor or solenoid? Inertia switch? Intake? Computer not giving codes
Hoked battery up backwards.then replaced main fuse. When you put key in run position and the check engine light comes on, it wil start. Turn off and turn key back to run and light doent come on and no start. The car w...
need to replace the 100 amp fuse for alternator and cannot find location of said fuse....have looked all over engine compartment
first gear shifter arm came loose, broken, couldn't shift. when car was towed and rolled off tow truck I think that clutch was not engaged because now something underneath, attached to shifter is also broke. what coul...
1991 mecury capric keeps shutting down. has a new fuel pump and ignition modual , runs a minute or so then stalls out again. wait awhile and it starts up and shuts off
1992 Mercury Capri Automatic Transmission, naturally aspirated, 1.6
have changed the belt and battery and still has the same problem, sometimes the light is dim.
when you pull off the plug wires while its running the first and second have no effect the third and fourth make it stall, there is spark to all cyliunders and good compression, also getting fuel, any help please
when the car is in gear it starts moving but the transmission will not shift
My car starts but dies immediately once I release the ignition switch
can u bring it forward a little to close gap?
car wont run it turns over fine. you prime the motor it will run then dies
ignition has a censor that i want to bybass. ineed my car ton get to work, but i can not afford a new key
Car will not start, most of the time, when it does it will shut off on you or wont start again. It is getting spark and there is lots of pressure in the fuel line. The inertia switch in the back is also ok. Any tho...
wont start but will turn over and over
I can't keep at idle it just stalls out. It runs smooth at 2000 RPMs and above
The belt keeps snapping...it looks like the alternator pulley is not properly aligned.
dose anybody know where i can get a flow chart that shows the rpm breakdown per speed
what is the max rpm i should be putting out at 70 mph