Mercedes-Benz S500 QuestionsRefine by vehicle
when you press button you can hear motor come on but nothing happens
when you press button you can hear motor turn on but nothing happens
it was elevating but not now. need to find a shop that works on it in Wilson n.c. can u help
previous owner already took out original hydraulic system...replaced it with regular. air hydraulics from strut masters. and it had sagg when i bought it. so i don't know if installing the universal kit they claim will fit my car and go back to its upright position ?
Once the vehicle is strarted comes back to original position.
Initially right side back (tyre)was going down.Garage people changed the valve block.Still it was going down,then they changed the RIGHT shockabsorber.Even then in the morning whole back side is going down.Can you give a reason for this and how to rectify this
The tracking is fine until the car is running, Then the tracking goes out at the rear. The shop guys say it is a air suspension problem but I have no problems with the suspension. They say it can be reset but I don't understand how this causes the tracking problem.
What could be problem. It only started after I got my struts repaired. And my key won't turn now unless I play with it for 20 minutes? Help
I was driving along and notice that my seat was getting hotter. When I looked at the door panel, I noticed that the heated seats llights were on. When I got home and turned the car off they stayed on. What do I do aout it?
I USED PENTOSIN (GREEN APPEARANCE) ALL HYDRAULIC FLUID FOR POWER STEERING ASSEMBLY (WHEN WARMED FLUID IS ORANGE/SLIGHT PINK APPEARANCE). AFTER COUPLE OF DAYS THE FLUID DRAINS OUT NO LEAKS VISIBLE. BUT DOORS ASSIST HAS BEEN BETTER, QUITE PLEASE WITH THAT ISSUE.
When I push the brakes my brakes lights come on for about ten seconds and then they alternate from my left to my right to my middle brake light. My dash reads esp abs and bas as well as brake light left brake light rite middle brake light check lamps. When I had the codes checked it was c0450 which was a fuel take pressure issue. What could this be and why is it doing this?
Key was left in ignition overnight
I had to disconnect the battery in order to replace a front air shock. Upon completion, I started the car and Command Screen is blank!
No controls on the command screen are working. Screen is black.
i'm starting to see oil mixing in with my radiator coolant. I/m trying to figure out what are some of the causes
Well I jumped car off due to dead battery. Now the tag lights will not go off unless I disconnect the battery. Please don't..