229
questions

recently had gas line replaced because of break in line. since then check engine light has come on---is it related?

How to reset brake wear light

The auto locking feature at 9 mph is turned off on my 2005 ML 350. How can I activate this feature again?

How many quarts of oil needed in oil change

How to take out front console ashtray to retrieve something behind it.

vehicle seems too soft riding, sways in even fairly slow turns, does not give feeling of control

After replacing a water pump a get the code p0106. What does this mean

When pressing the left rear interior lamp lens it does not light, but when door open it does. Also works from interior light switch. Probably lamp lens switch needs replacing. Can a novice do this fix?

My dash light just came on today showing a battery and flashing red. Does this mean a charging system malfunction such as the alternator or is it simply the battery needs attention?

When idling in gear I feel I am using excessive brake force to keep it from creeping. To the point the brake even groan a little at release and stop. It pulls too hard at idle. Is there a stall speed adjustment or firmware upgrade/adjustment to solve this or am I stuck with a faulty torque converter?

What is causing the problem, and how do I fix it myself.

I don't know if anyone has had this issue with their vehicle (approx 47,300 miles registered). This problem happened recently. At a minimal speed (approx 3-10 mph),there will be a rough "clunk" underneath the vehicle when releasing the accelerator/gas pedal. It feels as if the vehicle is switching to a lower gear or something rather. I dropped the vehicle off at the dealership almost 5 days ago. The service department is presently troubleshooting the problem. They mentioned it may need a transmission fluid service. I'm thankful that they arent just shot gunning a part. Has anyone here experienced the same issue? Fix? Thank you so much for any input.

On my instrument cluster in the mileage display it shows a wrench, the letter D, the number 4, and a minus sign. I know the one wrench means minor tune up but what does the number 4 and the minus sign mean?

We cannot find the location of part number 003-821-27-51, there are 2 areas. One is somewhere in the front seat area and the other is somewhere behind the back seat. please tell us exactly where they are so we can replace them. Email address is japanautobody@yahoo.com

how long should brakes pads last?

front brakes, rotors, serpentine belt, belt tensioner. an estimate on labor

Could you please give me repair price estimate for the following repairs;
Rack and pinion replacement, Brake pads, engine power belt, replacing power steering fluid

What kind of Transmission oil does my 2004 ml350 takes? on the service book it says MB certified! I am sure i dont have to go to the dealer to get it. Please help..
Cheers

type A service 1 ranch but what does the letter d mean ?

showing 1 ranch and the letter d ...should i wait until it shows me that i need an oil channge or whatever the problem is ?

what kind of power steering fluid do i need for 2004 ML 350

The navigation system withjin the ML350 provides an estimated time of arrival. I have noticed that the time varies significantly as I drive to my destination.For example I start out on a trip and the NAV system states it will arrive within 2 hours. It will change to to 3hours plus until it gets close to destination and then refvert to correct arrivasl time. I checked with dealership and they have no software updates ( 2 months ago) Anyone experience this issue

I have not been able to figure out where the leak is exactly, but right after i put more power steering fluid in the resevoir, I looked under the car and saw it dripping from a bar under the the front part of my car. Is that the power steering rack?

I hear metalic squeeking when the breaks are applied & when I begin moving the car. Not while driving or going over rough roads. Any suggestiions? MB Dealership has failed to resolve the problem

after I changed the battary, the radio never work again.
It keep asking for enter securety code. Please tell me how to do it. Thnnk you.

center console covering is coming apart

how to release spare tire

Mice are nesting in my cabin air filter and leaving acorns that drop into my blower motor. What is the procedure for removing the blower motor and in-cabin air filter in the ML350 so i can get all this junk out of my car!!

i planing to buy mb ml350 but after reading all this issued i not buying

where is the crankshft sensor located and how long will it take to replace?