Mazda Protege Questions
Unanswered Mazda Protege Questions
Ask a Question
Friend swears it's cracked head. I'm hoping jumped timing.No water in oil.
Replaced MAF indicator 1 year ago. Also changed plugs and wires recently and PCV about a year ago. I use synthetic oil.
I have read there is a temp sensor for the ECU (not the gage) that if reads hi will not allow the A/C to run. where is this bad boy located??
Was stopped at an intersection,engine started running very rough. I pressed down on gas pedal it ran fine for a few seconds then died. Try to start engine it will start and run for a few seconds then die. What's wrong?
New plugs, wire, points, mass air flow sensor and fuel pump.
Replaced the crankshaft sensor but it wasn't that cause it still doing it. HELP
Pulling and I pulled over and it wouldn't go forward or backwards
ACTS LIKE ITS FLOODED SPRAYED START FLUID DIDN'T HELP THATS WHY IM THINKING ITS FLOOED .. IT STARTS AFTER A LOT OF CRANKING.. BURNED 1 STARTER OUT ALREADY.. SPARK IS THERE LOOKED WEEK// WHEN IT DOES START IT RUNS GOOD...
ACTS LIKE ITS FLOODED SPRAYED START FUID DIDNT HELP THATS WHY IM THINKING ITS FLOOED .. IT STARTS AFTER ALOT OF CRANKING.. BURNED 1 STARTER OUT ALREADY.. SPARK IS THERE LOOKED WEEK// WHEN IT DOES START IT RUNS GOOD ...
trasmision dont chanfe after 3th gear stay on hight sound like high speed switch what you guys think its is. thanks Henry
air conditioning and heater blows only on high speed 4 but does not work on lower speeds 1, 2 or 3
when the car is shifted from park or neutral to drive,reverse or any of the lower gears, the idle would do a sudden drop and car will cut off. but if i keep my feet on the accelerator immediately after i shift in to g...
It shifts from low to 3rd. wont go into 2nd
Driving 55 stopped running and will not restart what caused it how can I fix to get it running
Was driving 55 when car stopped running and will not restart
Tried starting fuel but will not start
and it wont turn after firing just chugs
Still same and gerting worse whats next the injecter?
It feels like its sputtering when its running.
i ran a scan on the car and a code came up p1345 i was told that was the cam sensor so i replaced it and replaced the plugs and wires too. any thoughs.