Mazda B3000 Questions
Answered Mazda B3000 Questions
Ask a Question
I was driving down the road headed home when I noticed a light sounding knocking noise that knocked faster when I sped up and slowed when I slowed down. At home I put my truck in neutral and revved up the motor and th...
I am a Saturday mechanic. My truck has been on the fritz for a few months now so I let it sit for about 3 months with not starting it. I had problems with my truck running rough and a cylinder misfire. I replaced t...
Coil, plugs,fuel pump,
eough shift speedo not working od light flashing
Engine has trouble starting when truck sits for a few hours or more. Won't crank, just makes a loud clunk or click. I can turn the key, and it will clunk each time, and eventually it starts. Runs and starts up great when engine is warmed up. What's wrong?
Like I said, it runs and starts up perfectly once the engine is warmed up. If I turn the truck off and go to start it up half an hour later, it will start up with no problem. But if I wait too long, it gives me troubl...
When you turned the engagement switch on you could here it click now nothing. could it be a solonoid, fuse or switch?
Battery is new. Started 2 months ago fine.
Starts easily after initial start No check eng light
there is no door key with the truck.the only way to get into the locked truck is with the electronic door fob. did this vehicle come with a door key separate from the ignition key. the ignition key does not work in t...
steering wheel air bags did not deploy
I replaced the charcoal canister, vacuum switch, EGR, oxygen sensor and the gas cap to no avail. The check engine light has returned. I had the Knetchs sales associate again verify the code and it is again 1443. Probl...
I just received my truck back after getting a new engine and transmission. The fob was not working, but the shop said that it just needs to be reprogrammed by putting the key in the ignition and turning it on and off ...
Starts fine, runs smooth only hesitates at under 45 mph or like in 4th gear or overdrive, other than that runs fine
I tried to change the crankshaft synchronizer and the camshaft positioning sensor and it still squeaks the same if not a little more . think it might be the idler pulley or possibly but hoping not my harmonic balancer
The temp outside was 57 degrees. Is this unusual.
The 01 B3000 has more than 250.000 miles on it.
It's a automatic transmission and am sure it has something to do with linkage. I did find a screw on floor board but my son threw it away I gues
Parted the Mazda B3000 Sat. at noon it ran great. Got in it today Tues. and on acceleration I noticed a skip and lack of power. Now we did have a lot of rain Sun. and Mon. and truck was out side?????
the ignition turns and the lights all work bit not the starter