Mazda B2300 Questions

Unanswered Mazda B2300 Questions

Ask a Question
View:RecentAnsweredUnanswered
What do I need for valve head adjustment
The line is a u-shaped piece that carries coolant from the driver's side of the engine block to the coolant reservoir on the passenger side of the engine compartment by traveling behind the engine block. It also feed...
trucks that for 9 months drain fuel check fuel pump change the timing belt got it made sure it was back in time it'll turn over but it still wont crank what could be the problem with that I'll check the solenoid and t...
Started misfiring really bad running rough
I was driving about 55 mph when my truck completely shut down and so I tried to restart and it cranked over like normal(not slow nor any dimming of lights) just didn't seem like it was getting the last little umph to ...
The indicator lights flash off and on, even after the key is removed.
I have bought new master cylinder and slave cylinder and did bench bleed and gravity bleed. Still truck will not go into gear after I start truck. I have bled and bled both master and slave. What am I doing wrong.?
I come to a complete stop n idles normal then Boggs down again ,,,, I'm Clueless plz help
Anyone have problem with clutch/brake pedal linkage and bushings? Mine clunks when I depress the clutch pedal. It is definitely coming from the pedal pivot under the dash.
Truck was stalling and not starting when going on stop and go errands. Recently changed the fuel pump and filter problem now is it will stall when taking off from a dead stop however if the rpms are revved it will tak...
after matching up colored wires because plug was cut in half. I only have brake lights. need some type diagram of rear tail lights. seems like I have a couple extra black wire
I was reading a post on (therangerstation.com/foru...ad.php?t=14539)about clutch slave cylinders failing . Well on the post are a couple more links that take me to something different. Maybe its the cheap tablet I'm u...
Stays on about 5 seconds then stops. Doesnt happen often but today did it three times within 10 mi. What could be cause of this ?
I have noises coming from tranny area when the clutch pedal is depressed. It requires a little extra effort to shift to second gear. Pedal has to be touching floorboard to shift properly.Is shifting notchy with these ...
Check engine light is on and it came up with code p0340 changed it and reset it and the light is still on can you please advice?
What is required to get the dashboard apart to get to the switch ?
I need to know how to remove the dash board to get to the switch.
Driving down the road my truck will lose power and it seems to misfire. No problem while accelerating
where are the bolts that hold the transmission in?
I have tried pulling it from the inside, it will not budge.