Mazda B2300 Questions

Answered Mazda B2300 Questions

Ask a Question
View:RecentAnsweredUnanswered
Had the alternator replaced, now I need a smog and its not ready
i was crossing through a a river that had water and the water was covering the diesel filter and car just cut and could not start. i only manged to start it the next day but the engine was vibrating and producing...
Heater stays on burn my feet while driving to work !!!!!
when i pulled off the pully on the crankshaft the pully puller i used stripped the treads where the center bolt went
when in drive transmission slips to neutral when engine is cold. works fine when engine is warm. is that a major problem. what is the fix and cost
Is there a secondary selonoid on a b2300? could it be a bad relay? It sounds like clicking noise is coming from the thing attached to the drivers side fire wall with 3 wires hooked to it. not sure what this is relay...
Since the jump start the heat controls no longer work, the dash lights illuminate randomly,the vehicle is making screeching noises and loss of power when driving. Any ideas?
my mazda 96 b2300 (smallest one)standard transmition stoped while driving it and turns over but wont start, for about 2 weeks before that,everytime i stoped on traffic lights it would start failing like if it really w...
i have replaced the coil, wire harness, spark plugs, and plug wires
Truck sat without being cranked for a year. Everybody says fuel pump. I changed the inline fuel filter, no help.
I put new plugs new wires new power packs.new fuel filter.new fuel pressure regulator.i just dont know what it could be...when I give it gas it back fires and wants to stall.please help
Changed head lights yesterday and cleaned posts and connectors. All service is up to date and good.
truck was not driven for a couple of weeks. I have been outside beside it many times, no radio was playing. Today it was on and the doors were locked. Turned the radio off and clock still shows on. Is there a way ...
Installed a new oil pump still have no oil pressure the bearing are good and so is the shaft that come down to the oil pump... need to know what drives that shaft
1994 b2300 75000 miles
have a round flasher, purchased at auto parts store. looking for location to install
I have changed the fuel pump 3 times in one month!!! What is causing the problem?
and highway speed is achieved. The Check Engine light has been on and my shop cant diagnose it. Could there be a connection between these issues. HELP
Fuse box is on side of dash on drivers side. When you pop the cover off theres usually a drawing telling you what fuses go to and what amp it is. There isnt anything there and under each slot is a number and thats it
I've have'nt owned my B2300 very long so unfortunately I know nothing of it's history. Odometer shows 223,000 but does'nt work. Changed the oil and held at full level for a solid couple months. Then to my surprise (be...