Mazda 626 Questions

Answered Mazda 626 Questions

Ask a Question
View:RecentAnsweredUnanswered
The car just cut off and will not even crank over to start
my check engine came on i took it to advance auto they told me to replace the egr valve so i did check engine light came on again they told me to replace the egr vacuum solenoid but we were unable to locate it on the ...
I live in a small town where the car performs fine, even up & down steep hills, but after I've been driving on the interstate for 25 or 30 minutes it begins to shake & jerk. The RPM's will go up suddenly, as if I've m...
I need to replace my valve gaskets or seals causing oil leaks but I check levels before driving every time and now after replacing battery warning light is on constantly or sometimes blinks. Extreme weather is making...
My car wouldn't start so I jumped the battery had it checked and needed a new one. The day after it was replaced check engine light came on sometimes it would flash but mostly stayed on constantly. Occasionally idling...
My engine revvs itself in neutral, overheats, I smell coolant in the engine steam, and my heat is gone. I believe it may be the intake gasket but I'm not sure.
it still squirts water out but blades don't move
it had not been picking up speed like normal and would idle high at sporatic times
Mechanic changed cats, brakes, 2 sensors, checked vacumes are OK, engine is good..Car still misfires, feel like it wants to stall and dose from time to time...Can it be the computer it self.. Mechanic said it could b...
Engine light is on and has a - PO400 'A' Flow - code. Already changed EGR valve, solenoids and hose within the last month. Many times when pushing on the gas the car remains in a slow pace then slowly picks up in spee...
After this still have same code defect What next could it be after replace all new parts.Has anyone had this problem.
Replaced plugs, plug wires and coil still have same problem misfire #3 cyl. and no power on hills.
When using car it uses break fluid half of the master cylinder please help
p1744 says its the torque converter clutch solenoid. I am wondering where that is located and is it an expensive fix? It is a mazda 626, automatic tranny, 1998. The car starts shifting hard after the car has warmed u...
Whenever I'm in hill my car shakes and pops out of drive and reverses back and I have to push down on the gas so I won't hit and other cars and the same thing happens when I'm on a flat surface and it sometimes turns ...
Hooked the 626 up to a computer reader, and got a goose-egg on read-out having any major problems. Car idles a little low, then stalls on initial acceleration when driving in stop-and-go city traffic. It's fine on...
Problem happens all the time. Whenever I try to push the gas pedal, my car violently shakes, and won't accelerate, check engine flashes, a minute later the car is running again smoothly, until I have to go up a hill, ...
Will drive fine and then when turning off car, may not start right after its turned off or an hour later. Will eventually start up again. It cranks but no start. Took to a mechanic and it started fine every time. ...
So I just rebuilt my motor. New rings/valve oil seals. 3 cylinders run 1,2,4. 3 cylinders don't run 3,5,6. I have confirmed compression at 140psi on all cylinders. Confirmed spark on all cylinders. Timing is correct. ...