Land Rover Range Rover Questions

Unanswered Land Rover Range Rover Questions

Ask a Question
View:RecentAnsweredUnanswered
The back-up lights are functional and work. The third brake light, above the lift gate also does not work. Could the recent repairs created this new problem?
The knocking noise seems to last just a few seconds after the start up but then quiets down.
My husband changed the rear rotors and brake pads. Now I get this message, Transmission range change not available when I turn the key in the ignition. I cant switch the range out of low. I also get the message HDC fa...
My husband changed the rear rotors and brake pads. Now I get this message, Transmission range change not available when I turn the key in the ignition. I cant switch the range out of low. I also get the message HDC fa...
I've change fluid and filter. It doesn't smell burnt when pan was off everything looked really clean. It shifted better for 3 months after I done that but after I added just a little bit of tranny fluid bc it has...
The dash and everything else lights and works display on dash says hdc unavailable Ignition clicks does nothing else Parked car because the front right air strut was hissing had a hole in it took it off took out th...
When I compress my brakes, the pedal goes about half way down and then feels like it pops and stops harshly. I think maybe the brakes need to be changed but I'm not sure.
The fold in feature doesn't work as well. It folds in but wont stay in.
shifter moves up and down but wont engage in gear
4 ways come on and keep blinking. I think it may be the anti theft system. I need to know how to disable it or over ride it. The code that came up is P01000 even. Any help would be great. Thanks.
my car was diagnosed with that problem but I can't find the explanation can anyone tell me
I have undone the 3 bolts. it moves etc but I cant get it past what appears to be a mount at the rear....is there a 'knack'to getting it off??
Although weather strips on both rear-doors were changed two times at the dealer ,there is no change. Gum seals of lower-plate of rea doors do not fit to the under body.
blem it also burnt out when you open the pump the armture is burnt
is there a way to disable my alarm and clear alarm fault so i can start my car
But when u pull off she fills like its missing but then she run great after u get off the stop persion like a red lite. i change spark plugs change wirers and cap change oil change serpintine belt and it happens all t...
I drove my truck to work and when I got off I started the truck and it would not go into any gear. However, when I would move the gear shift from park to drive and then back to park, the gears would make a grinding s...
My land rover starts then immediately dies. Previous to this I replaced the water pump, serpentine belt and fan due to a failure in the water pump seal and bearing. I don't know if the two are realted but the rover ju...
my check engine light came on. diagnostic code p2402 and p2406 came up.
At varies times while driving the tailend will shimmy, vibrate and feel like I am riding on rough terrain.
Hi, it seems the transmission had hard shift on 1st gear, please advise