Jeep Wrangler Questions

Answered Jeep Wrangler Questions

Ask a Question
View:RecentAnsweredUnanswered
says "disc read error", says it is ejecting cd but it doesnt
I am trying to install a glowshift oil pressure gauge ssensor via a t fitting adapter but can locate an oil line.
Pulled in yesterday, all good. Today, turn switch, nothing. No power at all. All fuses are good.
as the vehicle is being stopped the brake is applied and when the clutch pedal is pressed down the rpm's go from 1000 to 2000 rpms. I replaced the air control sensor what else could cause this problem.
have new oil pump, screen,switch what should I do
going to check timing belt,break fluid,abs wheel sensor,abs control module replaced,oil light coolant leak, electrol system, vaccum leak diagnostic
My first thought was that there was a vacuum leak, but the engine idles and runs good.
So...I screwed up, and put a quart of 80W-90 oil in my front differential, instead of the rear. And...when I realized my mistake...I combined quarts of 80W-90 with 85W-140 (1.8 quarts) to put into the rear differenti...
I sent my ecu out to get checked. The guy told me the capacitors where bad and he fixed it and sent it back. I put it in and it did the same exact thing. The vehicle was running fine then just shut off. It cranks s...
changed to a brighter bulb, worked for a few days now won't come on, changed relay still dosn,t work
After a few seconds I can rev the engine slowly a few times and it returnes to normal , this jeep only has 34,000 miles on it and never driven off road or hard
front end wobbles at 55mph if you hit a bump
will start sometimes after a few trys has fuel but seams like no spark has code 33 i dont have a/c what does the auto stut downrelay afect and could that be the problum have changed the relay, coil, crank sensor
Engine fires on all 4 cylinders and has good fuel pressure running in neutral at the curb, both at idle and full RPM, but will miss and surge in gear under a load (while driving).
While driving down the freeway, I started hearing a noise, almost like one of those cars that sounds like a rice burner. I pulled off and when I tried to go again, I lost all power and could not go above 30mph. What's...
Jeep runs great changed out the electric fuel pump cap rotor plugs wires MAP sensor but does not idle
Jeep dogtracks after i ran over a steep downward pitch in the road at a slightly high speed...i heard metal on metal..after the that the steering is all sloppy very hard to change lanes...vehicle travels at a angle wh...
Check engine light comes on and stays on. When Barrera is disconnected light goes off and stays off until jeep is driven a distance of thirty or more miles at higher speed.
Driver side floor was full of water, actual puddle.
It runs goods at idle, starts good! Just started missing mainly when it being lugged around at half throttle! Also smells like it's getting too much fuel. Check engine light stays on now with a misfire code! Please he...
My 1994 Jeep Wrangler 4 cyl std hasn't been going over 50 mph. So the highway is a nightmare need help fixing the problem. I'm going like 50 mph on the 5th gear which is the last gear on the highway and the engine sou...
Missfire code p0300. On excelleration gas pedal clicks medal on medal and does not excellerate properly. Engine light is on and sometimes blinks.