Unanswered Isuzu Questions
Ask a Question
hold petal to floor rpms come up and runs good till you stop and start again boggs down
after starting vehicle, the low fuel indicator light, battery indicator light and brake indicator light on the dash stay on until about 3 miles of travel then go off? the AC will not turn on until indicator lights tur...
I have a 2002 Isuzu that started acting like it is flooded and the cooling fan does not come on. We replaced the fuel pressure regulator, that did not solve the problem.
2000 Isuzu rodeo won't shift into 3rd gear never had any signs of the Tranny going bad jusy woke up got in my truck an it started .ot will sometimes go into 3rd gear an so forth but 90% od the time iit won't go .
2000 Isuzu rodeo won't shift into 3rd gear never had any signs of the Tranny going bad jusy woke up got in my truck an it started .ot will sometimes go into 3rd gear an so forth but 90% od the time iit won't go . no l...
My driver's seat is power and has a panel on the side of the seat at hand level to adjust my seat. All adjustments work but the switch within the same panel that makes seat go forwards and backwards stopped working o...
We have had to change the ignition control module in the past and have changed it just this week since it's not ran. Not sure what else we can do?
Seam like the vacuum pressure is high also like my breaks r aplayed
The part in question has a plastic piece on the hose that secures it. It is also located below the altenator.
other gears are fine... we had this problem before with our ford Taurus and it was due to a leak we sealed the leak but the car ultimately gave up on us anyway. how else can we fix a gear shifting issue? or is it most...
I'm not sure if it could be welded or what other vehicles are compatible for that engine, 3.1.thanks
the antifreeze will not drain into the engine, why?
New gasket and grommets were replaced after the mechanic said everything looked good and suggested an engine flush and oil and filter change. The engine was flushed and serviced. The rattle and ticking noise is gone.....
I had a mechanic take a look at my lifters because there was a rattling or ticking noise coming from the engine. I had no engine oil leaks prior to him removing the value cover. I did buy new value cover gasket with grommets.
He said there seemed to be nothing wrong with the lifters. He did suggest an engine flush. So I bought the engine flush and oil and filter. He said he flushed the engine. Did the oil and filter change. The engine was...
replaced head gaskets test started and it ran shut down to finish puting on the fan and shroud and air cleaner and now it will not start no codes
I have a 2007 ascender. My vehicle service stabilitrak message lite stays on permanetly