Isuzu Rodeo Questions

Unanswered Isuzu Rodeo Questions

Ask a Question
View:RecentAnsweredUnanswered
The part in question has a plastic piece on the hose that secures it. It is also located below the altenator.
other gears are fine... we had this problem before with our ford Taurus and it was due to a leak we sealed the leak but the car ultimately gave up on us anyway. how else can we fix a gear shifting issue? or is it most...
I'm not sure if it could be welded or what other vehicles are compatible for that engine, 3.1.thanks
the antifreeze will not drain into the engine, why?
New gasket and grommets were replaced after the mechanic said everything looked good and suggested an engine flush and oil and filter change. The engine was flushed and serviced. The rattle and ticking noise is gone.....
He said there seemed to be nothing wrong with the lifters. He did suggest an engine flush. So I bought the engine flush and oil and filter. He said he flushed the engine. Did the oil and filter change. The engine was...
replaced head gaskets test started and it ran shut down to finish puting on the fan and shroud and air cleaner and now it will not start no codes
the old girls got 267,000 ml. On her. I hauled her out to AZ. from TN. & when I unloaded it I noticed a small spot of what looked like hydraulic fluid on the ground. Right below the transmission. Looked around for wer...
Seems to happens only when I start it and sounds like I'm ready to run a drag race,it calms down when I pull the connector next to the iac valve. I am getting a code for map sensor
Went to start car and both the oil gauge and the gas gauge lost power and the car would not start! Cranks like crazy, but no spark! Have checked all 3 sensors, and 3 different meters are not getting a reading at all! ...
This morning it won't start. Seems like it wants to, but doesn't fire up. When running it seems OK at high rpms, but when more power is needed for going uphill for example, it misfires.
Very cold about year ago car started ended up with fuel in oil. Took to shop drain And new oil added. Now reduced power light comes on occasionally and goes into limping mode. When check engine light on cruise don't w...
Leaking trans fluid out of bell housing...
4 wheel drive 3.2.I need to access a leak on the manifold crossover pipe :( :P
whats the order to tighten bolts and the torq lbs used?
When you turn the key you hear a click and it blows a fuse. We replaced the starter with a new one and it still does it. It has been to a mechanic several times for repair. They changed out 2 relays even though it cr...
My 2003 Isuzu v6 Rodeo engine locked up. I found a 2000 model and I was told I would have to use the Original intake and throttle body. Is this true?