GMC Yukon Denali Questions
Answered GMC Yukon Denali Questions
Ask a Question
I replace the gas cap but the light still keeps going on and off
front axle wheel bearings only
the 30 amp fuse controls the driver seat and both passenger windows and seat. when i replace the fuse it blows out after 5 minutes. the fuse also controls the heated seat on the driver side
Checked alternator and battery not the problem. I will leave it sit for a few minutes and it will start right back up and maybe die again a little while later. Started again this morning and then died about 5 miles ...
Looks like I have the same issue as many others...electrical. My battery keeps getting drained by something. No one can figure out. I will get off a 13 hr shift, car starts up fine. Drive to market, shop, car star...
the back door isn't automatically closing it starts, when it reaches half the way in reopens.
I have a 6.0 liter engine and was getting 6-12 mpg in town and 14-28mpg highway. My fuel pump was just replaced and I am now reading 18-27 mpg in town and 6-7 mpg highway. Idle is high and car self propels. I can d...
is this normal, should i get it looked @ while its warrented thank you.
4wd makes a bad noise in 4wd gm says theres a recall on other vins but not mine but i have the same problem what do i need to do
Won't lock from the inside or the keyless
When hitting the switch the lights dim slightly,all other windows work fine
I have a bunch of water on my passenger side floorboard. I was told to check the AC drain to make sure it's not plugged. Sounds simple but don't know where it is located. Thank you for your help in advance.
Scrapping and when u put Ty our foot on the break to take it out of gear you hear a pop
It will stay on max 80 for 20-30 seconds, then drop to 0 for 10-15 seconds, and keep repeating this pattern. Engine light has come on as well.
I tried. Everything. I need help.
radio indicator will not light up. The service man at FH Dailey informed me I need a new radio. Please verify that it is ture.
hi pressure switch melted on back of compressor. replaced switch compressor not engaging put scanner on truck showing a/c request but not engaging can ground one leg of relay and a/c engages .at PCM #43 green wire a/c...
this has happen twice and the last time I soldered the connection but still melted plug