I am interested in buying a 08 hybrid yukon 116000 .it has a new factory installed original not r...
Questions for specific GMC models:
- 1500 Pickup
- 2500 Pickup
- 3500 Pickup
- Rally Wagon 1500
- Rally Wagon 2500
- Rally Wagon 3500
- S15 Jimmy
- Savana 1500
- Savana 2500
- Savana 3500
- Sierra 1500
- Sierra 1500 HD
- Sierra 1500 Hybrid
- Sierra 2500
- Sierra 2500 HD
- Sierra 3500
- Sierra 3500 HD
- Sierra C3
- Sierra Denali
- Suburban 1500
- Suburban 2500
- Vandura 1500
- Vandura 2500
- Vandura 3500
- Yukon Denali
- Yukon Hybrid
- Yukon XL 1500
- Yukon XL 2500
- Yukon XL Denali
GMC Q&AAsk Your Question
All GMC questions
yesterday I put $25 worth of gas using a different pump than I usually use. After driving a litt...
I have an envoy 2003 and I noticed that the car had been cut into two before and re-linked
I maintain the vehicle very well through a well trusted shop. The periodic low speed stall occur...
tried to start next day and blew muffler wide open. engine does turn over but has extreme miles o...
The problem is happening every day we have replaced the ignition coil, oil change and o2 sensors.
changed fuel filter, fuel pump runs, trouble code for low fuel pressure and crankcase position se...
My truck is a 2010 GMC Silverado 2500 series HD . I would like to know some reasons why the truck...
sometimes and sometimes it won't start. Let it sit for 10-15 min and it starts. Any sugges...
I have replaced master cylinder, calipers, rotors, pads, speed sensors, and flush out the complet...
the scenarios are all different. today in the automatic car wash the window popped open
We have change the oil sensor and the oil pressure still goes down so the next thing is the pump ...
I have replaced the throttle body and need to verify engine speed
I think it is the light that tells you it is time to change the oil but I just had the oil change...
Will this vehicle function properly as a 2 wheel drive vehicle if I remove the drive chain from t...
We replaced the alternator but something is sucking the life out of the battery, might be a wirin...
ive blown two master cylinders and now replaced my slave but still cant keep constant pressure to...