Ford Fusion Questions

Unanswered Ford Fusion Questions

Ask a Question
View:RecentAnsweredUnanswered
this is from the dealer should i shop around for shops?
Throttle problems
Changed out the hardware and pin boots adding lubrication. Drive side is almost like it has continuous pressure. I have always changed my own brakes, never have seen this...
The passenger door latch issue seems to be a common theme with 2013 Ford Fusions. I experienced the same issue today, and am riding around with my car door taped shut because the Ford dealership estimates that the cos...
For auto door locks, speedometer works and "Check Engine" light comes on.when speeds of around 60 mph are reached, eng seems to stall and jerks. Speed sensor has been replaced.
Engine runs rough, gear do not shift when shut engine it does not start unless use spare key. Engine light remains on. Dealer said computer bad changed it and have same problem now they says that dash board gadget has...
The airbag light comes on and off intermintintly and some times low tire pressure when they are not low.
After car warms up and I leave and turn corner transmission feels like it is dropping and bottoms out.
While pulling out of a garage my passenger side mirror hit a wall, breaking some of the casing around the mirror and causing it to be flimsy and not very useable. Local Ford dealer is estimating $650.00 for the mirror...
my car started shaking every time im driving on the freeway around 50-70 mph and every time im at a red light holding the brake pedal it shakes the steering wheel shakes ,but when i put it on the (PRNDAL) N or neutral...
on the driver side back wheel starting making noises, smelling and was smoking when I got my vehicle back to my drive way. Can't drive it. What should I do? Thanks.
My check engine light came on last month for a day. I started the car the next day and the check engine light was no longer on. It turned back on yesterday and has been on since. Today while I was driving on the highw...
i have brought it back to the dealership several times, and the technician keeps telling me nothing is wrong after test driving it for a few miles.
Car was in for a new timing chain. Something happened that damaged the engine. Stopped by to check on car status to find garage dropping a replacement engine in my car. Was never notified this was happening. Should I ...
Replacing the bearing, but the hub will not budge. I've used a slide hammer, bearing puller, mallet, sledge hammer and it won't free from the bearing. I've lubed it, pulled, hammered and the thing won't come loose.
connector is actually an assembly that dealer says requires complete harness replacement. if i had the assembly there is enough slack to cut and splice. no need to replace harness. i gotta believe that somebody makes ...
Yes i asked you about the 2011 ford fusion 4 clyinder cold ussing the 6 speed automatic shifting problem first few times taking off it slips like into 2nd the service manager told me let it warm up he does his then it...
we got 2011 for fusion sel 4 clyinder 6 speed automatic its not all wheel drive but has all ther options when its cold start if you get in it and drive it and not warm it up it will shift into 2nd like rpms go way u...
While driving on the freeway, the brakes became very stiff, had to use both feet to stop. I have had no other issues with the brakes until now.
when trying to start with remote car does not start horn blows ,when i get in car must put key in turn on then off ,then can start car with key