Ford F-350 Questions

Answered Ford F-350 Questions

Ask a Question
View:RecentAnsweredUnanswered
the truck will run if i induce fuel through the plentom. I have changed many parts all of witch were corroded or looked bad. i do to have low voltage at the inertia switch, i do have 12v at the relay, i changed the pc...
Question Asked: Brakes on a 1990 F-350 4x4 7.3 diesel. I have replaced the whole system.. January 31, 2015, 03:19 PM Meaning the back drums and front calibers, I also have replaced the booster, master cylinder, & th...
I was plowing yesterday morning and I went to the gas station to get diesel I get in to leave and put it in gear and no motion what so ever just a little crawl .. I added some aft and was able to drive about 5-6 miles...
truck is "88" never a problem like this, has fuel, new filter,just cranks an cranks till batterys get low,no computer, hope you can help,its been sittong for about two weeks now!thanks
My volt gauge is down around 9 or 10 when idling. I installed a new alt and new batteries and it would stay around 14/15 volts, but now only 8/9 when at idle. The terminals for the battery cables are clean but very ha...
If there is a recall and I take ny truck to a Ford dealer is it going to cost me anything?
Truck has a gerling brake system,and it has a thumping noise in the brake pedal and the pedal shifts back and forth a little each time you hear the noise.it only does it when the parking brake is released,the noise se...
On a Ford 8000 chassis,where is the clutch master cylinder located?
when i came back to calif. i was about 3mi to go then i had engine power loss could not go up the slightest hill only 3 to 10 miles per if i speed up the engine turns off. waited awhile then inched my way to thousand ...
Truck jut got out of a transmission rebuild and engines was runnin great before and now overheats and won't go over a certain speed and needs high RPMs to change gears.
my truck idles fine but when I go down the road it gets a mis in it I changed the plugs, coil, wires, cap, rotor, cap and plugs and still cant find the problem anyone out their help me out I hope someone has some ideas
Had just put my plow on went bout 30 miles on highway and smoke started to pour out of coolant over flow tank. Stopped and checked it the cover blew off. I made a make shift one and got about another 10 miles and the ...
using too much oil, not leaks, no smoke, plenty of power
it only sounds when I drive in potholes I have already change both top and bottom ball joints also all tie rod ends and still
misfire and quitting during acceleration when warm
I just replaced plugs, wires, cap and roter. I readjusted the wire routing. Still rough running and misfiring
oil is blowing out of pipe going into engine
Rust in fuel system. Will not start. Changed both fuel filters.
i wont to no if i can put in a c6 instead
If I don't start the truck daily oritsits formore than 10 hrs it won't start. runs smooth as silk when it warms up. no missing is there a check valve that allows air into the fuel lines because it sounds like it...
I haven't driven the truck often. When I parked it, it was fine but water in tank light was on. The filters were changed. The tanks were cleaned out and fuel pumps changed. Batteries (2) are new. Could it be the fuel ...
with new fuse, what can i check to take care of this problem?
also put on new throtle position sencor new plugs,wires cap rotor.it seemed to start after i put new coil on?
Drove the truck for almost a year with only one battery and no probs.Took a road trip and turned it off after 400miles and it would not start.Cranks, but won't turn over.Bought one new batteriy and it cranked fine but...