Ford Explorer Questions
Answered Ford Explorer Questions
Ask a Question
Can u tell if engine is going to throw a rod? I wanted to tuneup because I'm driving to Oregon this wknd from OC.Truck had oil changed 2 days ago.
Was told by repair person that light is on because of evap valve - went online to see where that would be located on 2002 ford explorer but not finding one for this make Can you tell me where it's located? - also tryi...
Is there a chart or grid to diagnose and test 4wd contol module for 2002 ford explorer
It works sometimes than it stops working. No defrost or heat of any kind why?
a mechanic had referred to them as upper and lower ball joints. but when i try to price it out only lower is mentioned. thanks for any help
my light wont go off so I need to pull the fuse
Explorder misses at 45-55 MPH and typically stops when you move beyond that range. It idles fine and is not indicating any fault codes at this time. Explorer has done this for approximately 6 months but has recently...
Replaced Fuel pump, Fuel Filter, Fuel pump relay, Fuel reset magnetic switch and fuel pump driver module. Still have problems to get the fuel pump to work when trying to start with the engine cold, I have to put the s...
leaking in all 3 lines
when trans cool it doesnt slip or blow fluid . after hot slips and blows fluid.when this begins to happen trans makes a slight roaring sound
Do I just change the valve,or is there any computer updating to do?
I need to get to the resistor for the fan.
This happens after the door might have been opened for no more than 10 minutes. Also this happens when I might be charging my cellphone. I'm hoping I don't need a new battery.
what's the problem when my clutch is in gear and it takes a couple seconds to catch then I step on the gas and I start to get very very slow momentum and it smells like burning clutch? I do have clutch fluid in it. What's the problem?
When its in gear and I step on the gas the engine revs up and it takes a little while for it to catch for me to start moving and it smells like burning clutch.
when going to the bank it has happened that the engine would not start , it crancks ok , just would not fire up , after a while it will start normally again , had the same problem with another car and that was the pro...
Just recently changed intake and valve cover gaskets
sometimes they blink forever and other times one or two blinks and done...going either way what needs to be replaced and where in the fuse box is it located?