Ford E-150 Questions

Unanswered Ford E-150 Questions

Ask a Question
View:RecentAnsweredUnanswered
I have had problems with shuddering from 30-45 mph all the time. Occasionally I will experience slippage. The slippage seems to happen when weather is cooler and takes awhile for the gear to switch out of 1st into 2n...
v6 4.2 lt.changed egr vale and senser coilpack wiers plugs air filter gas filter stil runs the same.any help
Replaced tie rod. Ball joint seems stable, but won't take grease.
changed coil wires, coil pack, plugs, air filter....problem was happening before these repairs and after the repairs had been made...happens every time I drive
My vehicle will not start,no fuel pump pressure. No power to the #7 fuse,anyone know what to do?
Van has front and rear heat. Need to replace all of the hoses. Parts store says it takes 5/8 and 3/4 inch hoses.Need to know how long each one is (does one go to the back and the other from back to front?)Also, I can'...
The steering is hard to control because the vehicle wanders from left to right. It's worse at higher speeds. I'm constantly having to correct it and it's much worse when passing a semi or in strong winds. What is ca...
van running fine , I changed valve covers, now will not start AT ALL. I've replaced coil, ICM, Starter solenoid/relay. Still nothing I am with out a vehicle for last 3 days ready to go NUTS.... HELPPPPPP
Is there any diagram for the transmission i know that probably sounds weird but i want to know what it suppose to look like after i take the pan off!!! Any help or advise would be much appreciated! Karmell0
is there anyplace online to find a video that shows how to get to the blend door I've seen lots for the F-150's but can't find anything for the vans mine is a 98 need to open the door for the winter
I replaced the pump and the loud whining sound continue so I replaced the replacement pump with another pump and the sound is still there. What do you think it could be--rack and pinion?
99 ford e150 4.2 v6 auto with od 163,000 miles was running perfect shifting fine it had 1/4 tank of gas i drove around most the day no promblems then i stopped and filled gas tank up 30 some gallons and added some stp...
I replace the distributor and did a tuneup when it first started doing it six months ago,the tack also stopped working. The problem is back and now it is also cutting out while driving, almost like turning the key off...
trying to put on seat covers over the back
will the coil work and be running bad at high speeds
A mechanic replaced the worm screws or drive just as they were. However, I just bought it so I'm not sure they were correct to begin with. The bed tries to move into a sofa but seems to get stuck before the middle can...
So when u turn on back ac it blows ac but after a few hit and miss the floor heat turns on in the back. Has anyone else had this happen have any ideas? When hooked up to diagnostics it shows no problems.
had some smoke from the wires on the master cylinder and burnt the wires to the ABS can you please tell me why the master cylinder got so hot to melt the wires thank you
It started hard but would start after pumping the throttle. After it started it ran great. It kept getting harder to start.I have lights and power but it won't turn over.This may not have anything to do with my proble...
After a few seconds you can hear it power back up and you can start it back up and go a little longer.