Ford Questions

Answered Ford Questions

Ask a Question
View:RecentAnsweredUnanswered
Now the car won't start after putting it back. How can I resolve this
when at low RPM my heat or air goes where I have controler set. Then when RPM is increased it goes to the defroster until RPM goes down. Then it returns to where I have it set to. Do I need a new part? It appears to...
In drive while stopped at red light vehicle vibrates then taking off it jerks. But while in motion its ok. While in park or neutral its good. Hearf it can be motor mounts I don't know. If it is about how much will i...
my 99 ranger 2.5 engine gives a 304 miss fire code when its raining or damp outside. I replaced both coil packs wires and plugs,this did not fix the problem.
The original problem when I took the car to the shop is it would stall while idle. After the MAF replacement it sometimes drives fine and other times will stall when I give it gas. The IAC did not seem to change perfo...
applied electret grease to the pcm and bulkhead connector, replaced the distributor electronics,r&r crank sensor,ignition mod on the driver fender, new plugs, all started when rain crank no start, replaced plugs ,cran...
I recently bought a 2001 ford mustang from craigslist and it seems to have an engine knock, we have changed to oil and it seems to be even louder... We are starting to believe its the lifter valve but not sure..
the check engine light came on & was steady - disconnected battery & after reconnecting the light went out & hasn't appeared since - just drove 50 miles without tranny hesitation, but prior to that, it hesitated twic...
661 blocked passage 662 filed EGR valve663 EGR solenoid faulty 664 failed EGR pressure sensor 665 failed EGR position sensor
Didn't pass the inspection, the reason "NOT READY" they told me that I need to perform a drive cycle. The gas pump isn't working promply, doesn't mark the gas level on the dashboard. It could be this the reason for th...
While driving its ok just when it'd stopped in drive. It vibrates, shakes. In park iys ok
In two weeks time, my truck has gotten worse. First was glow plug light staying on and no fuel flow when trying to start. Then last week started shutting off after first get going. Problem is getting worse. If I g...
my truck idles rough and my heater will not blow hot , but yet the temp. is normal so it's not the thermostat,what could it be?
I already checked the inside fuses. All other lights work just not the break lights.
Engine pulsates up & down, up, & down "at cold start only," then runs evenly, but lacks major power. Bad Gas Millage, but no emmisions smell really. It's a 3.0liter short-wheel base van w/ rebuild 80,000miles ago. It ...
my truck overheated and i found oil in the rtadiator
Needs to pass inspection but engine light stays on and they tell me its the sensor'but'which one I hear there are 4
Need to replace Ecm, and need to know how to get to it.
fuses look good ; including 7cb, & 8; there is no relay relating to this system; I also checked the door module
had just changed the valve cover gasket and replace the throttle with a crown victoria throttle