Ford Aerostar Questions
Answered Ford Aerostar Questions
Ask a Question
3.0L. I can't see the EGR Valve from of van, nor through dog house.Where the heck is it? Below?Local Auto Parts Stores tell me conflicting stories.Some tell me it's located off the intake manifold-(which I already knew)-others say it Don't have one?
Engine pulsates up & down, up, & down "at cold start only," then runs evenly, but lacks major power. Bad Gas Millage, but no emmisions smell really. It's a 3.0liter short-wheel base van w/ rebuild 80,000miles ago. It ...
I am trying to change the spark plugs on my 1995 aerostar and am unable to get to the passenger side
After running out of gas it started bogging and sputtering at times.
thermostat changed, heater core changed,temp gugage low at all times. Cardboard in front of radiator raises tempature gugage still no heat. remove cardboard and gugage immeadately drops back
I changed the fuel filter and still having trouble with it boging out at 50 and 60 miles per hour. I like the van it only has 70000 on it just need alittle help.
I cannot find the brake filler cap. I see the oil, transmission fluid, antifreeze, window washing fluid and power steering but I do not see the cap to fill brake fluid. Can you tell me where to fide it?
took the distribitor cap off and found a broken router button. replaced cap and button still want start and its not firing. whats up?
Chirping clicking noise started at rear of engine about a week ago. 178,000miles on engine. Ford aerostar 3.0.
I loaned out the van; it came back with the side door not being able to open. I've tried locking, unlocking, prying, and removing the top inside panel, but not a budge. How do I get it open before it can even be fixed?
Has been running rough for a while. Happened before and I put it in neutral and pushed it forward then in drive then park and it started right up. Then drove 1,00 miles no problem. Each time after sitting a day or tw...
Small amount of air comes through the defrost when any of the positions are on the dial. Can't get A/C to come through the proper vents How do I fix?
Is my engine blown
Oil sending unit seems ok; I apply gas w/ brake to maintain a steady gauge at stops. I have added "no leak" to oil, and it helps for a while. I thought this May be vacuum problem with regulator valve on side of tran...
With the engine running the temp indicator slowly rises to about the o in the word normal then drops down to cold. This cycle continues throughout the entire trip. Rarely get hot enough to warm the car,
I get a loose feeling clunk when going over bumps and potholes, I have high pitched whine on turn. Thick sludge is present on driveline/ujoint side of diff housing. Previous owner replaced broken trans with rebuilt on...
Even after driving 5 miles the front air system only managed to blow lukewarm air. The engine was at normal operating temperature after a couple miles. What do I need to do to resolve this issue?
tranny problem was working going fine and just failed
To clarify my previous questions, I want to say that 1 time when I was on the frwy, I had to gun it to get on and after that , the engine made some noise. Then , something started bouncing off the ground in the back a...
I didn't get to finish from my earlier question. With frozen brakes, rear end busted, I Have to tow it.
AS the rear end started making noise, the brakes started to freeze up and then release. How much to fix this?
Started after my son replaced the speaker wire, told me that it got coughed somehow when he was pulling it,
Both cables by gas pedal has the plastic adjusting part broken how do I replace it?
both locks mechanism are broken inside, how do i replace them or repair...
cruise control stopped working the fuse is good. I think the vacuum line is off where does the vacuum line go
The blower does not blow
Can anyone tell me where to find the sensor on the back door that turns off the dome lights
new plugs,wire's,coil pack,02 sensor,isc motor.good compression vacuum steady at 18 motor has valve train noise after warmed up changed rocker arms & push rods on #4,#5,#6 head motor runs & sounds 50% better code po30...