Dodge Ram 2500 Questions

Answered Dodge Ram 2500 Questions

Ask a Question
View:RecentAnsweredUnanswered
Are Prostart, ToughOne, and Gold Duralast standard brands? What is recommended?
I have changed the TPS with a new one and cables/connections look and test fine. I cleared the code, the problem still occurs but only when turning on the a/c. The a/c compressor works fine. The a/c system has a lo...
Whether the truck is idling, driving, or just starting. 90% of the time it blows hot air. Dealer says freon is fine and they replaced valve. Any suggestions?
My battery went dead jumped it when i drove it the speedometer dont work the ac dont work heated mirrors dont work the outside temp console dont work i had it checked for codes says bad speed sensor i replaced that no...
Wires were ripped out of the speed sensor plug on the rear of the transmission. I can't figure out which wire goes were. Its a three wire connector. Can any one help?
My truck trough a p2299 and I know its from driving with two feet but I was pulling a trailer and had to on a hill but point being my truck is dead on power sounds like its running on half the cylinders and loads up o...
It happens if I floor it to go it falls on its face,then I let off it it starts going again
engine starts and idels just fineuntil you give it more throttlr
I have changed my injector pump for a rebuilt one and installed a raptor lift pump also, at the same time. Truck no longer has symptoms it had before and is more responsive etc. but still getting code 0216.
After driving on highway approx. a hour my diesel sometimes does not respond to me pushing on the pedal. If I let up and push again it responds. Always after highway driving and has only just started this. Not everyti...
engine wouldn't start. Poured fuel down throttle body. Engine ran. Checked fuel pump. Fuel pump runs but pressure regulator was plugged. Replaced it. Engine ran for 20 seconds, starving for fuel. Checked Map Sensor, a...
I did a partial tune up changing all but the wires, even changed distributor cap. My air intake housing has gaps, most of them I covered with duck tape. It sarts fine, and for the most part runs fine, but it acts like...
I was driving and it started acting like it wasn't getting fuel then it died one after I got it to start back it would not go when it was in reverse or drive park works and neutral work
need to know how I could fix my truck the truck starts up u have to keep your foot on the gas to keep it goig it seem like their is no idle >>? its weird need help plz
when using the heater there is no in'between as far as temp control either the heat is full on or full off
THE TRUCK JUST DIES WHEN AT OR ABOVE 210 DEGREES. CODES ARE FOR CRANK/CAM SENSOR IGNITION OR POSSIBLY TIMING CHAIN.IF I REPLACE SENSOR WILL THE NEW ONE DEVELOPE THE SAME THERMAL FAULT? DOES IT NEED SOME KIND OF HEAT S...
shaft retainer tabs need to be clipped off before installation
It feels stiff and I have very little acceleration I've changed cap rotor wires and cleaned throt.body and no change what can I do to correct this problem please
I'm reading a lot on the need to replace the stock fuel and injector pumps on the dodge ram 5.9. I read that the stock pumps will definitely fail and once replaced they will be fine forever, if you go to a different p...
After my truck gets up to normal running temp my motor will quit. I've had it happen with the truck parked and while driving down the road. It will not start again till the truck cools down. I've replaced the ignitio...
The fuel-supply line quick-connector on my Dodge Ram van is leaking and it is impossible right now to purchase a replacement of any kind.I examined it and has concluded that the vinyl o-ring is the problem,not the rub...
the power steering was very good before i put the gear box on i tried getting the air out of the lines for an hour and no change and the power steeringpump is serculating and i had good breaks still does any one have ...
there has been 15 people looking for it on my motor and nobody can find it
Dodge ram van 5.2L ; I have had a catalyst and evap monitors flashing on my carmd code reader for over a year.I have replaced both oxygen sensors before and aft. Driven the van numerous times stop and go etc. Do the f...
Started truck this morning, got the power steering whine as usual when very cold out. Went to store, no problem, came out started right up, no whine but no power steering or brakes. Whine started back in a block or so...
I removed the resistor which is in the upper part of the a/c box and looked at the 3-springs.All are intact.
valves knock what do I need to do???