Dodge Ram 2500 Questions

Answered Dodge Ram 2500 Questions

Ask a Question
View:RecentAnsweredUnanswered
My 2002 Dodge 2500 2wd reg.cab 8 ft bed 5.9 cummins truck was cutting out when it was cold has a fault code 115 for engine speed sensor. Tried finding promblem and couldn't so pluged in to with a snap on scanner on th...
My left, rear turn signal and my right break light will not work. I have cleaned the connections with wd-40 and I installed all new bulbs in both rear tail light assemblies. I also put some bulb grease on the new bulb...
Truck won't start or even turn over.Red light flashing on dash.Battery has never been changed and has been cranking a little slower lately but it is not dead and nconnections are good.Any help would be greatly appreci...
I have a manual transmission. My interior lights were working and there were no fault codes. I installed an uplift pump and a new radiator, a fuel sender unit, a windshield wiper motor and 2 batteries. Now I am get...
When I start the truck the oil pressure gauge is a little high, but then goes down; but each time I start to drive and give it gas the gauge rises each time I push the gas..What could be wrong?
My parking lights the two ambers up front and the four reds on back wont go out even when you turn theignition off they stay on when engine is on and light switch is off too only way to make them go off is kill power ...
how do I repair fuel gage. Checked fuses (unless fuel gage fuses are located elsewhere). What else can I check?
shakes a little when you have the overdrive on around 35 mph when step on the gas slower
The engine will crank over but it will not start. The lift pump has been checked out and is good but when you turn the key on the lift pump doesnt come on...The ignition switched as been checked and it is also good..P...
To adjust the bands on my 4speed auto tranny i need to know what type it is 46re, 47re or 48re How do i tell? All three have different adjustments
The left headlight, nor the left plow light work on low beam. Tried a new isolation module and that didn't help. Any ideas?
heat is not work when i stop and start work when i driving what would cause that
Response: no warning lights. Just changed filter and fluid. No change.
Shifts ok when cold. When warm, hesitates until RPM's 1500 or more. If it does shift into 3rd, it will immediately downshift and try to shift again. Am able to get home at 30 mph; no more.
my blower is only working on high, and the heater will not blow continuous heat... when turned down for a few seconds then turned back up it will blow nice and hot air for a few seconds and then back to warm... what c...
so thats what i need to do is to take the batteries and get it checked.one other thing if i remove the batteries wont the memories be all erased.
It was tested by an multimeter and it read 12.5 volts.
related to same question below.
i tried to start my truck and it doesn't want to start.when i tried to start it, inside cab lights,my gauges starts flickering,my gauges moves up and down.i've checked all my connections and it is all good.batteries a...
After i shut my truck off, the mileage flashes 4 times then says no bus and it stays on the no bus does not go out. if I don't drive my truck after a little while it will drain my batteries. Well I am guessing that i...
My truck has a small plactic ( motor or pump ) located on the passenger side at the fire wall it has wires and a 1/4 inch hose attached. This motor just started to run almost all the time, when the key is on. Does any...
is a throttle valve actuator the same thing as a throttle valve position sensor?
how to remove bearing hub and rotor
front rotor replace 1999 dodge ram 2500 4x4
all brake lights stay on. i replaced the brake light switch yet problem still persists. had to remove fuse number one to kill lights.
The turn signals work sometimes and sometimes not. The signals blink fast sometimes normal if working.
I have a ram diesel 2500 237000 miles. I had a, what i would say a clunking sound at 5 mph forward or reverse. I changed the universals,carrier bearing. It still did it. I took the drive shaft out and took it to the l...
while replacing broken bolts on manifold the manifold does not line up with the bolt holes on the block
cranks 1st thing each day, after engine gets warm, will not crank until it cools off,(cold days are great)acts like it's getting no fuel, has been on diagnostic machine 2 times,still no answer, thanks in advance for A...