Chrysler Town & Country Questions

Unanswered Chrysler Town & Country Questions

Ask a Question
View:RecentAnsweredUnanswered
I saw an old post about the 2006 model transmission having a shift bearing linkage that breaks. Where is it located, internally or externally?
The enine code is po 301 cylinder 1, misfire
How do I remove the right headlight assembly from a 2010 Chrysler Town and Country? There is one bolt at the top, but I cannot see the fasteners that are holding the bottom of the assembly in place.
I just had my safety test done and failed because my parking brake (according to the mechanic) does not stop the car from rolling. I would rather not pay them to fix it. How do I go about the adjustment?
this does not happen consistently. is there a sensor issue and how do I find it?
I have a 2001 Chrysler Town and Country Limited w/ a 3.8L 6Cyl. The TCM is giving me a P0605 and P0700 Codes and it is making the van run in limp mode. (Not passing 2nd gear). I understand that the TCM needs replacem...
When I'm driving 55 to 60 mph I notice a front end shimmy.
I have replaced motor, wiring harness and latch actuator but door still does not work (driver side). From the beginning, when bottom pressed, door would release but would not open or close. Only sound was a clicking ...
AFTER I CHANGED MY BATTERY CABLE MY RADIO WILL NOT COME BACK ON. HOW CAN I FIX THIS THIS PROBLEM
check engine light came on
High beams will come on if I hold the lever so high come on but will not stay.
My engine lite is on, I was told I need a new transmission computer and solenoid? I have no clue what they are talking about and how much would it cost? This car have been well taken care of. The engine light is on. S...
100000 miles - going uphill transmission slips
Do I need a control module or is it the electrical hook-up?
I bought this minivan, and had i diagnosis done on it , it came up with no numbers, but at the dealership , he said i need the motor mounts replaced, but don't know , how much they cost , to replace, also the front re...
I am not a mac. have worked on old cars but not the newer ones are the lifters easy to change
I have a 2002 T&C, 3.8L engine. At first, it was stalling at low speeds or when idling, so I replaced the throttle position sensor. That stopped the stalling. Then, it began idling fast (1500-2000 rpm) and shifting...
The A/C works fine on the passenger side but the driver side comes out warm.
ok,i was off taking my niece to bowling and after putting the car in reverse,and then about to drive,it died,after several attempts to crank it, the engine did not want to "turn over"..seems like may not be getting fu...
My vans hazard lights and dash lights won't stop blinking whether the van is turned on or its off. This is causing a huge problem because it is running my battery dead at night. And suggestions?
The front driver’s side electric seat is not functioning. The passenger seat is still working. We are unable to move it out of its current positions and cannot find any fuses that would be causing this problem. We als...
When I connect the cruise control, the signal gets on but the control doesn´t work. Where can I get a diagram of the whole system, in order to identify the parts and try to find some failure?
rainny day so when i turned on the winshield wipers front of van ok but when i turned on the rear wiper the check lite came on !!!! any connection ? it fail for EGR related failure when i did the smog a week ago had t...
my driver side power sliding door was working fine then all of a sudden when you hit the button to close the door, it starts to close but when it gets about 6 in from closing it stops and opens again. sounds like a se...
I need to replace my starter and this is the first time and I don't want to take it to a shop.
I know this was a Chrystler recall problem but that has expired my main question is ...do I have to remove injectors to get to the o ring ? if not I can probably fix myself
when you turn on the a/c knob nothing happens
After coming from work and parking my minivan the next day while when I tried starting it the van cranck, started and ran for a few seconds then it stop. I did this twice. Ever since the van has refused to start. I ...