Chevrolet Tracker Questions
Get answers to questions about your Chevrolet Tracker at RepairPal. Find solutions, diagnose problems and get back on the road.Refine by vehicle
We were told the routers and brake pads needed to be done when my husband wtarted he realized the routers were fine. So he replaced the pads now it's rubbingagainst the routers and seems llike the caliber isn't sitting right. So my question is what could cause the pads to rub like that; the routers, caliber, or axle? You can hear it scrape.
I have a 2003 chevy tracker
I ALREADY CHANGED THE FUEL PUMP,FUEL FILTER,CRANK SENOR AND SPARK PLUGS
Flasher was taken out and put back in due to my left signal would not turn off. When he (husband) put the flasher back in the car has no power.
The timing belt had just been fixed and the car has never run better. While driving on the highway there was no shutter, no smell, no lights on the dashboard but the engine just died. Tried turning the car over on the side of the road and tried turning over (no smell or no rough noises under the hood while cranking the key). When the car is turned on all lights come on on the dashboard and car dies after a few seconds of turning key. Took to Auto Zone to see if a code could be read to give us a hint and no codes were being given. Were thinking it might be the Alternator but we just had that checked at Auto Zone a week prior and they said it was still good. Any help would be greatly appreciated.
I recall this happened last time I removed battery cables for cleaning and then the engine wouldn't idle, then after some time it would idle, I dont recall what fixed it, I'm sure a component or sensor needs to reset, any help would be appreciated.
When I drive my car 30 miles or more the floorboard becomes soaked with water and I have no clue what to do for it. Any suggestions are appreciated
is this something a diy can fix?
I think clutch whent out but would like to look at slave first
my drivers door window wont wind up with out me pulling it back about a 1/4 inch it goes down fine
hello i just replaced new rad,new cap new thermostat, cooling fan and both rad hoses and heater hoses now when i run the a/c or my defrosters my compresser n a/c cooling fan pulsate causeing my engine to run poorly
cap, thermostat, new heater hoses , new rad hoses and new a/c cooling fan now when i try to run the a/c or defrosters the cooling fan and a/c compresser pulsate
my car make a knocking sound that is coming from the left side of the pistons. If you are looking from under the hook. It smokes when you crank it up and it is using oil also.
I was driving my Tracker when the clutch pedal unwelded I did get it welded but wasn't in when they took it apart I need to know how to intall the pedel 1999 Chevrolet Tracker
What does a new exhaust system cost for that?
My 2001 Tracker has lost all it oil. The oil sprayed out over the front bumper. Any idea where the leak is coming from as we can't see anything.
What am I missing? Is there a adjusting bolt, do I have to take it off, or WHAT?? I need to replace the belt. it broke and my wife wants to drive my truck, Please Help
When removing changing the spark plugs one was broken. How bad is this? expensive to fix? car has about 140,000 miles.
blew a golf ball size hole in the metal above oil pan on passenger side. what parts do i need to fix this or do i need a complete newmotor
i need to no what type of tool i need to remove lock nut from cv axle on passengers side.
I;ve repaired it once prior, can I( just take it out of the system?
It does it all the time
does the drl control the taillites as well as front lights?
blower fuse keeps blowing,blower been changed fuse still blowing when running air or heat.What could be the problem
i made the mistake of pumping the brake pedal with the drum off ,now i cant get the drum back on.
I have a leak in my air condition, have put freon in in about one week it was working and then it got warm did not hold the freon. but i really want to know where is the evaporator located at.
engine oil pan is leaking
can the oil dip stick be removed by way of the oil pan
I don't have a manual.