Chevrolet Suburban 1500 Questions

Unanswered Chevrolet Suburban 1500 Questions

Ask a Question
View:RecentAnsweredUnanswered
It has air bag suspension it sat for like 6 months,now it doesnt have the ac because it all was removed lines are still open,but the truck starts right up everytime then shuts right back off 3 seconds later
Will go down and up but stops before closing about an inch from the top.
Last Friday I turned my Saburban on and put it into drive. Everything was fine as I drove a short distance, until came to a complete stop at a red light. As the light changed to green, I released the brake to creep fo...
This is a follow up question on the 2006 Suburban shifting problem. What if you have power to the IGN 0 fuse? What is the next step.
ecu codes P0740, P0753, P0758, P0785, P2761 and also getting a P0446 Emissions code. The transmission codes is intermittent. The car works find for a day or two and then has the shifting problem until it resets which ...
We have done everything we can think of but the brakes are still struggling and feel like they are still on while I'm driving.
I start the car but it does not move, nor makes any nose at all. I was going to try to see if it is a fuse but I am not sure which fuse it is. Can anyone let me know which fuse is it, and if it is located in the fuse...
today is Tuesday (4-7-15) went back to auto parts for other things and it didn't want to start aging, lights come on every think is working just don't start and now that I think about it, it did it that Saturday went ...
I lost my owners manual. Illustrations would be greatly appreciated. Thank you.
I had to replace the entire light case due to water. Then I changed all the bulbs and it was fine for 2 days then one burnt out due to water again. So I changed the whole socket and now both don't work. I checked the ...
While driving the truck will just stop - no warning - just dead. I roll to the side of the road and try to start it - sometimes it starts and sometimes it won't. It just dies when it wants to - no warning lights com...
Took wiring harness apart and found melted black wire (ground?) connector. What do I do now? Both the male end and the female end are burned. I am a novice when it comes to car stuff...only figured it out by reading o...
My codes came out to be p0300 radom misfires & the other was p0327 knock sensor ineed t know what coul be wring with my truck thats misfiring what can we look for i just did a complete tone up on the truck sholud i ch...
Runs a little hot although gauge does not register.seems that fluid is needed although oil transmission and coolant levels r fine
I'm trying to find out if it is most likely just the blower control or if something else is likely to have gone. When I try to turn on anything heat or a/c related it does nothing at all. Do you think the control swit...
Drive shaft broke while wheels were spinning on ice. It fell out from underneath car.
It made a clunking noise forward and backwards and now no reverse at all
fluid level is good not burnt tranny or transfer case?
Heater was blowing cold air today but eventually started to blow hot.
quit was full of metal tech said it was a bad torque converter truck ran good but had the code after that then lost 3rd and forth in 1000 miles clutches were fried ,could the tcm be causing this,tech says he doesnt no...
I know its related! Warning light first, then gauges kicking on and off, finally rpms jump up and down and the motor ends up dying! The only code it gives is p0108. I expected a brain problem.
sometimes it show correctly but most of the time it show empty with the need fuel light on. the car has 149,000 miles on it and the fuel pump was replaced at 130,000 miles
Turn over. The starter has been replaced. It doesn't do it all the time. I drive it everyday. Usually when it does this, it will start right up about a half hour later. What can I do to fix this?