Chevrolet S10 Questions
Answered Chevrolet S10 Questions
Ask a Question
I took it to a transmission shop they think it is the transfer case how can i be sure before i spend money to replace something that may not fix the issue?
dose not work. when i clear codes the gas gauge gose to full and back to e
Engine sounds like it has a exhaust leak when cold and white smoke comes out tail pipe then when it warms up it stops smokeing and quites down.
My 95 chevy s 10 4.3 Z Started running really bad sometimes to the point it will shut off. The transmission stops shifting like it should when this is going on. I was told that the temp control sensor was bad. I repla...
Engine runs fine when Idling,when you accelerate with warm engine is when the missing starts. Runs fine when engine is cold. replaced fuel pump, filter.
Cost to replace upper/lower ball joints
None of the warning lights come on when the key is turned to on. The gas gauge needle sometimes points straight down, the battery light flickers. The starter doesn't turn over and there is a ticking sound coming from ...
Gas gauge stays on full with key on. When you turn the key off it goes down to 3/4 full. What do I look for to correct the problem
leaking fuel around the fuel injector really cant see anything do i have to take the whole intake off to find out where its leaking
When the car is off the breaks are tight and at the top of compression...when the car is on they are still tight and take an extreme amount of pressure for compression and the car slowly comes to a stop...at stop the ...
it started about 3 months ago and about a month ago it stopped working all together.
My 4 wheel drive starts grinding like it's trying to engage, when I engage the 4 wheel drive it stops grinding. I've replaced the vacum switch, and the vacum lines.
pressure only rises to about 110-120 and the guage only ranges fromm 100 as the lowest.
I HAVE REPAIRED ONE FREEZE PLUG ALREADY AND NOW A SECOND ONE IS BAD AND NEED TO CHANG. UNFORTUNATLY, ITS BEHIND A BRACKET AND IM BEING TOLD, I MIGHT HAVE TO PULL ENGINE TO REPAIR BECAUSE OF ITS LOCATION (FRONT OF BLOC...