Chevrolet S10 Blazer Questions

Answered Chevrolet S10 Blazer Questions

Ask a Question
View:RecentAnsweredUnanswered
4x4 switch no longer lights up and 4x4 hasn't worked for long time. Trying to figure out where to start? Is the switch a replaceable part found at places like o'reillys? I also looked at fuses and all appear to be goo...
fuel pressure 55 lbs and holds plugs firing properly any help out there
will not start on its own fuel pressure 55lbs and has ignition to plugs stumped.hate it cant figure it out any suggestions from anyone
idles high,even after warm
i have tried several stations so that is not the issue this has been going on for months and i need to get this fixed due to a big trip coming up next month
Last winter parked my vehicle first outside, then inside, vehicle sat for a while, wouldn't start. put treatment in gas, still wouldn't fire. Bought some parts to change out, debating on junking the car out. Bought a ...
how do I engage the 4 wheel high on a 1994 Chevrolet s10 Blazer am I supposed to be driving while doing this or am I supposed to stop and put it in neutral?
What kind of oil should I use to change the transfer case fluid
just started one day (no changes made,(not even new gas...
The compressor clutch wont engage. When I went to try to manually engage the thing, I couldn't find any relays for it. If anyone could tell me where it might be, or how to manually engage it without one, that would ...
my break pedal goes to the floor making stopping a bit difficult. my fluid is not low- there is no visible signs of fluid leaking any where. manual suggested to back up and hit breaks to make rear breaks adjust. this ...
I have a 92 Chevy S10 Blazer. A few weeks ago it started stalling in idle, and has gotten worse. Now it stalls in idle and then when I try to turn it back on it will crank but won't start. When I turn the key to the o...
My oil will get overfull. it is not water. I did pull top part of intake and thought it to be a gas leak. On theleft side it was clean and had what apeered to be trans fluid in bottom. Right side was black with sut an...
driving the truck now has no power and dies out like the fuel pump isnt working properly but in idle runs fine and revs fine and I connected everything back properly
black smoke until I hit the throttle
I have replaced most vacuum lines but the line from the carb to the vapor canister when I take it off it does not change anything no difference?
we have pressure bled it, vacuum bled it, and bench bled it, still can't get the clutch to disengage...we also put in a whole new clutch pilot bearing and pressure plate...very frustrating!! What else can we do? We a...
it hits really hard like it has a shift kit maybe i just purchased it a week ago
I need to replace the rear transmission seal, how much would it cost
My truck is a Chevrolet s10 it has a new cluch but the other day I was driveing. And when I went to shift the cluch had no Presser and went straight to the floor I'm not sure what it is but I have the tools an everyth...
any solutions that i can check i put high grade gas and try driving it but stills run a little rough
Sometimes it'll stall without putting it in drive. I can pull each plug wire off one at a time and it stalls,which makes me think each plug is firing. I recently replaced the coil. I cleaned the portal for the IAC and...
Sometimes it'll stall without putting it in drive. I can pull each plug wire off one at a time and it stalls,which makes me think each plug is firing. I recently replaced the coil. I cleaned the portal for the IAC and...
i replaced the fuel pump at the tank. but now still not run. i check fuel relay no power. can any one help me? yes i replaced the icu thinking tha was my problen and still dont have power at the fuel relay. please help.
fuel comes on changed fuel filter put on new coil does not appear to have spark or fuel.