Close

Chevrolet Colorado Questions

Get answers to questions about your Chevrolet Colorado at RepairPal. Find solutions, diagnose problems and get back on the road.

Refine by vehicle
×
Choose your vehicle
No car image 94a1663db56199c5353592009e34aaa51078a2469bed068bb8d6f0ba43accf97
Get a Repair Estimate
Guaranteed by certified locations nationwide. Learn more
RepairPal estimates are guaranteed at over 1,700 quality certified locations nationwide. Learn more
433
questions

gauge barely moves off peg. Still have heat.

my battery has been changed and my alternator is fine but my battery light wont go out. I have been told its my battery control module.will it drain my battery if i dont change it right away?

Got my oil changed a couple hundred miles before it was due, and about 2 weeks later a digital "Change Oil" message came up on my odometer. It goes away when I hit the trip reset, but comes back every time I start the truck. How do I reset that irritating little message?

i changed the vehical speed sensor thought that could be the problem and still does not work and the engine light stays on?

the clip that holds the spring in the arm broke could not get it back on i the decided i would replace the arm i removed the nut but can not get the arm off

My truck is leaking antifreeze what seem to be somewhere behind the fan what can it be and how to fix it?

#3 setting was not working, so I replaced the resistor block. it stopped working again, so I left it that way.
Then, #1 and 2 stopped, only # 4 would work, but the problem was intermittent.
i ended up replacing the resistor block again, together with the knobs in the dash...It worked for one day, and now #1,2 and 3 do not work

the window goes up very little and comes down just a fraction of an inch.i have in channel deflectors on the truck. the dealer said that was the problem ,so I took them off. it still the same way . any solutions .

thank you

It happens always durning fast acceleration or slowly I can feel it more when starting out and going up a hill.

body control module

actuator or module fix this problem

the next day driver window and door locks quit only driver window the other 3 work on crew cab unhooked batt is there something i can reset some way or a module to change

it has no lights on i put gas at chevrons and shell gas stations and try to put the most expensive gas i can but nothing works i really need help i have a newborn and its dangerous that it keeps stopping when i make slow turns like u turns.

Chevrolet does not recommend a brake fluid flush unless I have my brakes replaced. What is the sudden push for this service?

after I got my truck back, it will run until I get to 22 mph, and the transmission skips and will not allow me to go any faster

The brake handle will pop back on.

2wd was hard to do a couple of times and now wont go at all

engine controls fine, cruise control works, no codes, Worked intermittently now has stopped at full deflection/ scale. Looked underneath, wiring looked fine on tranny housing. Could the sensor be located on the engine?

the wire harness was check for broken wires andbad connections

Gas nozzle will not will not fill up tank with out cutting off a 100 times. I can hear air coming out but that should affect the gas nozzle thou. I need help with this bc its so frustrating getting gas. It takes about 30 mins to pump a tank full. Is it a frequent thing?? It has only done this to me the last 5 times I have been to fill up.

On a 2007 chevy colorado

transmission leaks where dipstick enters

what can cause a cylinder misfire?? Code P0305 !

when I disconect the battery wait reconnect wait 10 to 15 minute vehicle start up.

suspect negative wire Are they hooked together?

Chevy replaced the head under warranty around 35k miles for cylinder 5 misfire. Truck now has 142k & getting misfire code. Don't know which cylinder yet.
Coilpacks still original, replaced the plugs around 128k.
Any advice?

the cd players plays the cds but when i hit eject it sounds like it is trying to eject but gives ck cd error

Its not the fuse

just crank. I you crank very long it has a security sensor that will kick in. When that kicks in I have to wait ten minutes before attemp to start it again. After the ten minutes it starts every time. What can i do to fix this?

no mention of one in the manual