Chevrolet Blazer Questions

Answered Chevrolet Blazer Questions

Ask a Question
i was told it was located under the motor by the starter, nope
all I realy need to do is change ruptured preesure line.can I do this without pulling pump?
My ac blower was not working on any speed. I changed resister and now it works on high only. Any ideas on why 3 other speeds don't work ?
My car lost power going up a hill. The RPM went up to 3-4 and the speed decreased from 70-30 MPH. The car then started again and I got it up to about 50 and then 70 but then back down to 30 and then eventually the car...
my truck needs 4 to 5 turns to start and when it does it ticks when i accelerate and while idle
when I try pumping gas into my blazer it will only take about 10 cents at a time
I was driving the blazer and it was making squeaky noises from the passenger rear tire it felt like the tire blew I pulled over and put the car in park when I went to put it in drive the drive shaft spins and it won't...
actuator is pulling with vaccum. Light is flashing back to 4wheel high not engauging in 2wheel or 4 wheel low.
I remove all the bolts from the pan, the housing. Also the remove the starter. The pan just won't come off.
after it slowed to 5 mph put it in park, now engine is extremely loud like its going to blow up and no oil left
Can't figure out why security light comes on but won't go off or blink
I can open the rear window and tailgate, then close and lock up car all lights go off car alarm is on and everything is fine. Next morning I start car, the overhead light stays on like a door is open and dash says t...
and the trans mission doesent want to shift right what could be awrong with it
bought a blazer off a person i do my own mechanic work he told me it was running but then hit a deer has a new fuel pump in it the ignition was broke still is, i have and extra computer, coil, crankshaft sensor, cams...
how to remove a bumper from a 96 chevy blazer
I replaced the multifunction switch..The wipers were not functioning correctly, cruise control won't work so I replaced the switch..Now I can not get the ignition switch to work..I am guessing that I don't have someth...
when I come to a stop sign, my brakes will slide. I have several time gone through a stop sign. when I pull the fuse for the abs out of the top of the fuse box. my brakes are fine. however I loose my 4 wheel drive wit...
The blazer is a 4x4, it will turn over, but its getting harder and harder with mutiple cranks till it does.. i had the battery replaced and a basic tune up of wires and plugs , but the problem continues.. once it star...
it's warm to start it again. It seems like it isn't getting gas or not firing properly. Any help would be appreciated !! Thanks
My 03 blazer engine light came on...scanned it bank 1 sensor 1 changed it with new one reset day light came back on...po1035...checked fuse good..what wires and what voltage from the truck sides connector??