Chevrolet Blazer QuestionsRefine by vehicle
Why's it run like a new one when I get it started and still has a small hesitation in starting it afterwards unless it's it's four five six days then it's hard to start
Random miss occurs only at idle and only when at normal operating temp and only when the AC compressor is running. Not throwing any codes.
it just happened a few days agon when he was trying to get it fixed for me
It sounds as if something is winding up when I accelerate. Was told it was the rpm in the motor running up. But rpm gauge don't indicate this and its shifts fine. Had wheel hubs replaced.
Wouldn't take a jump! Battery is fine lights and radio are working! I turn key and not a sound!
The reason I am asking is because I was just on craigslist looking at the chevy blazer that someone is selling and I was reading the details about it and they said that one of the problems with the blazer is the manifold so I was just wondering is someone could please be so kind as too helping me figure out what that is?
I had changed camshaft fuel pump and pisiotons with rings after that my engine is not starting and no current passing in sparkplugs and coils also
The lights on the dash suddenly switch off and not long after my truck cuts out and will not start again.
I've taken it to a mechanic and they can not find the problem, they sent my truck on to an auto electrician and they could not find the problem either. This has happened before and both places have been unable to find the problem.
I had a callout mechanic come out as I was stranded and he said that the engine was draining the battery rather than powering it, I informed the mechanic and auto electrician of this but they still were unable to fix it.
The problem has since come up again but this time it is worse, the truck will cut out without any warning.
Any advice would be helpful, thank you
The reason I ask is I have to order a new one! Thanks
Is it common for the door hinge pin to almost disintegrate? This is the second blazer in our family 98 and both have this issue.
When I was changing the rear axle on my 2000 Chevy Blazer 4x4 I noticed a spider gear slipped out of place the axle bearing and seal went bad so I was changing it first time this has happened how do I take care of this do they have to go back in a specific order or can I just line them back up with a pen and they will be ok
How to replace universal joints
It runs for a couple days then problem starts again.it's also a 4x4. Has 75000 miles.
Would it be the water pump or thermostat and what's best way to figure it out it seem according to Guage it went up hot at one point came back to about 200 and then went to zero but I know I was still hot. I let cool added water to overflow drove it home, where should I go from here???
also changed Brakelight switch
How much cost for repair? How long for repair?
I Have bought a new cylinder but without key cant go further I don't want to drill it out and don't have 200 to pay for dealer to replace Any suggestions?
car runs fine in 2 wheel drive. won't shift into lo or high four wheel drive when selector on dash is pushed
Think fuel pump and maybe fyel sensor?
Whatever and for awhile it would start and then it would not, arbitrarily
I got an OBD II code reader and it tells me hahaha. Help
checked all fuses they all were good.
I attempted to Turn key on but leave engine off .. then turn on heat/ac controls .. turn on blower fan 1 speed at a time through ALL speed settings ..
Nothing happens when switches are activated
no defrost, no floor air
Vents do not blow any air at all. AC motor does not sound like its on when turned on. Could it be a fuse ? thx
I've got a 95 Blazer 4 x 4 automatic i'm changing to a five speed manual i'd like to find out about the clutch slave cylinder what it looks like and how it sits in the transmission
Check engine light stays on--new radiator, intake gaskets, replaced #4 and #6 spark plugs (code reader said they were bad?), distributor cap. Compression's at 80 but should be 120. Won't pass smog. Help!
leaking from 2 fuel lines
service light comes on take it back . service people tell me . they don't have not knowledge to fix it. and they want to send me up north. under warranted
I have a 2001 Chevrolet blazer auto when I got it the 4x4 wasn't working. I checked all fuses and noticed the one under bonnet was blown so I changed it. and the 4x4 switch wouldn't let me select what I wanted. It was stuck in 4x4. And when I drove slowly it felt like the hand break was on. and it really struggled in reverse. Then the service 4x4 light came on and fuse blew again. And then it drove properly again but without 4x4 or any lights on selector or the service light on.
I am trying to locate the "Orifice Tube" to change it in case the screen is clogged.