Car Q&A Community

Answered Questions

Ask a Question
View:RecentAnsweredUnanswered
First I want to thank "autotechpat" for the reply to my question last week. Did what I was told and it all worked out. Now here is this week's question: driving back east from Las Vegas, taking I 40. Will be goi...
how does the alternater come out
key pad on door stopped working.fuses look ok.light not comming on when i push buttons.what fuse controls key pad?what can i check next.
going down interstate the car jerks a couple on times then quits pulling. Put it in gear - rev.&drive you feel the transmission engage but won't pull the fluid smells burntdo i need to replace the transmission or is t...
My car is running hotter than normal. After driving for about 20min it starts to heat up to 200-205. If I slow down or stop the car heats up to 205-210 I have changed the thermostate, flushed the coolant, and check...
Hello, I own a used Chrysler 300 M with 133,000 miles on it. It recently started running out on me... I kept water in it and always pulled over on the side of the rode once I noticed the temperature gauge started to r...
2.4L w/dual cams, car started leaking iol between cylinder head and engine block in the rear at driver side corner,.. was told by x-owner he changed engine, but i believe he replaced the cylinder head only , is it po...
fuel gauge on desh slowly goes down to empty(when full)and will only come back up when you refill it.
I have anti locking light on a couple of times on r/h top corner of desh , last couple days it hasn't come on ,but now it's come back on ,do you have any thing I can try to fix the problem?
I recently had new Sach's struts, bearing and bushings installed. From the moment I picked the car up from the shop there has been a rather loud "growl" or "groan" sound when I turn the wheel either direction. Could t...
do the calipers need to be removed in order to repalce the pads?
faulty shift control system what does it mean can i fix it my self
What would be a reasonable range for parts/labor to replace an instrument cluster? Are used an option and worth the risk?
do i have a filter and if do can i change it
I am having difficulty fitting the brake pads back into the clips...how exactly are they supposed to fit inside the clips which are inside the caliper?