Volvo Problem Reports

RepairPal Verified Volvo Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The front control arm bushings wear out, resulting in alignment issues and squeaking and/or knocking noises from the front end. Worn bushings will require replacement.

The front control arm bushings wear out, resulting in alignment issues and squeaking and/or knocking noises from the front end. Worn bushings will require replacement.

The front control arm bushings wear out, resulting in alignment issues and squeaking and/or knocking noises from the front end. Worn bushings will require replacement.

 

The front control arm bushings wear out, resulting in alignment issues and squeaking and/or knocking noises from the front end. Worn bushings will require replacement.

Several issues occur with the door locks on the Volvo C70 and most are because of the door lock assembly. What happens is that one door will not lock while the other one does. In other cases you will lock the doors and then one of the doors will immediately unlock.

The problem is that the door lock assembly is defective and will need replacement. Replacement of this assembly on the C70 is very difficult and is not recommended by a novice. Getting the door and window aligned properly so that you don't get air or water leaks is very, very difficult.

The gear position sensor on the transmission may fail, resulting in illumination of the Check Engine Light and/or a no start condition.

The gear position sensor on the transmission may fail, resulting in illumination of the Check Engine Light and/or a no start condition.

The gear position sensor on the transmission may fail, resulting in illumination of the Check Engine Light and/or a no start condition.

Mass airflow sensor (MAF) failures have been reported, causing engine idle problems, as well as acceleration hesitations. The Check Engine Light will normally illuminate when the MAF starts to fail.

One or more door lock assembly may fail and cause door locking/unlocking problems.

One or more door lock assembly may fail and cause door locking/unlocking problems.

One or more door lock assembly may fail and cause door locking/unlocking problems.

One or more door lock assembly may fail and cause door locking/unlocking problems.

It has been reported the mass air flow sensor may fail, resulting in illumination of the Check Engine Light.

Knocking noises going over bumps can be caused by worn sway bar end links. These end links have small ball joints that become loose and rattle. Replacement is the only fix.