Suzuki Problem Reports

RepairPal Verified Suzuki Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

An oil leak may develop form the right front axle seal. Our technicians tell us a revised axle seal is available to correct this concern.

An oil leak may develop form the right front axle seal. Our technicians tell us a revised axle seal is available to correct this concern.

An oil leak may develop form the right front axle seal. Our technicians tell us a revised axle seal is available to correct this concern.

Creaking of squeaking noises may be noted from the sway bar bushings. Our technicians tell us revised bushings are available which should correct this concern.

 

A harsh downshift from the automatic transmission my be noted on deceleration. Updating the transmission control module (TCM) software may correct this concern. Software revisions are commonly most helpful on newer vehicles. once the mileage builds up a worn component could cause similar problems. Whenever major transmission work in performed, the transmission software should be updated as necessary.

A squeaking noise or vibration may he noted from the driveshaft area. This can be caused by failing universal joint which will require replacement.

A noise may develop from the rear driveshaft center support bearing requiring replacement of the failed bearing.

There are many reports of low beam head light bulbs burning out prematurely. As of this writing Suzuki has not released a service bulletin addressing this issue. Using only high quality replacement bulbs, and extra care not to touch the bulb surface when handling the new bulb can help extend the life of the replacement bulbs.

The head lights may stop working due to a failed connection at the multifunction head light switch. Our technicians tell us there is a harness connector repair kit available which should be installed in conjunction with dielectric grease to seal the connector. 2004-2006 models have been recalled for low beam and daytime running light malfunctions. For more information on this recall, please click here»

The airbag light may illuminate due to damaged wires under the drivers and/or passenger front seat. Damaged wires should be repaired and properly secured to correct this issue.

The AC condenser fan motor may fail. If this occurs the air conditioning will stop blowing cold air.

The Check Engine Light may illuminate due to an EVAP system purge fault. Our technicians tell us there is a powertrain control module (PCM) software update available which can correct this concern.

The brake pedal may pulsate upon brake apply. The common causes are overheating from heavy braking an/or improper wheel torque. Our technicians tell us that brake pads and rotors should be replaced to correct this concern. Problems may arise from aftermarket rotors due to quality concerns. This applies to both front and rear disk brakes.

The brake pedal may pulsate upon brake apply. The common causes are overheating from heavy braking an/or improper wheel torque. Our technicians tell us that brake pads and rotors should be replaced to correct this concern. Problems may arise from aftermarket rotors due to quality concerns. This applies to both front and rear disk brakes.

Multiple electrical system failures may be due to defective or damaged insulation at the wiring harness inside the left front fender liner. Any damaged wires should be properly repaired and repositioned to avoid further damage.