Scion Problem Reports

RepairPal Verified Scion Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The AC evaporator drain hose may become dislodged and cause a water leak on the passenger floor.

An illuminated Check Engine Light could be caused by a defective VVT-i controller, which changes cam timing for optimal power.  Updated parts are available and the repair may be covered under the powertrain warranty.

An illuminated Check Engine Light could be caused by a defective VVT-i controller, which changes cam timing for optimal power.  Updated parts are available and the repair may be covered under the powertrain warranty.

An illuminated Check Engine Light could be caused by a defective VVT-i controller, which changes cam timing for optimal power.  Updated parts are available and the repair may be covered under the powertrain warranty.

Air conditioning that doesn't blow cold enough could indicate the need for adjusting the cable for the temperature blend door.

Air conditioning that doesn't blow cold enough could indicate the need for adjusting the cable for the temperature blend door.

When backing up and applying the brakes, you may hear a squeaking noise. Scion engineers addressed this problem by modifying the shape of the brake pad and the anti-squeal shims; they also applied more grease during assembly.

When backing up and applying the brakes, you may hear a squeaking noise. Scion engineers addressed this problem by modifying the shape of the brake pad and the anti-squeal shims; they also applied more grease during assembly.

Vehicles with an automatic transmission may illuminate the Check Engine Light with code P0713 stored, related to the transmission fluid sensor. Our technicians tell us a revised, internal transmission wire harness is available to correct this concern. The harness does not require transmission removal to install.

Some vehicles may develop a condition where they cannot be shifted from "Park" to "Drive" and/or multiple warning lights illuminate when exposed to extreme cold conditions (-14 degrees F) or lower. Our technicians tell us the ignition (IG) relay should be replaced with an updated part to correct this concern.

Some vehicles may develop a condition where they cannot be shifted from "Park" to "Drive" and/or multiple warning lights illuminate when exposed to extreme cold conditions (-14 degrees F) or lower. Our technicians tell us the ignition (IG) relay should be replaced with an updated part to correct this concern.

Vehicles fitted with remote start may encounter a dead battery after sitting for a few days. This can be due to a parasitic draw caused by the remote start computer. Our technicians remind us proper diagnostic procedures should be followed before replacing the remote start module with an updated part.

Vehicles fitted with remote start may encounter a dead battery after sitting for a few days. This can be due to a parasitic draw caused by the remote start computer. Our technicians remind us proper diagnostic procedures should be followed before replacing the remote start module with an updated part.

An extended cranking or no start condition, and/or illumination of the Check Engine Light with codes P0300-P0304 and/or P0015 may be noted. Our technicians tell us updated powertrain control module (PCM) software is available to correct these concerns.

Some engines may experience a brief knocking or rattle on cold start up. Our technicians tell us replacing the camshaft timing gear assembly with upgraded parts will generally correct this concern.