Oldsmobile Cutlass Problem Reports

Newest Oldsmobile Cutlass Problem Reports

Report A Problem

Illumination of the Check Engine Light can be caused by a loose or worn gas cap.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Our technicians tell us that operating the engine  with a coolant/oil mix can result in internal engine damage. Replacing the intake manifold gasket should correct these leaks.

Corrosion may develop at the connection between the ignition coil tower and spark plug wire resulting in an engine misfire. The Ignition coil and spark plug wire should both be replaced to correct this condition.

An engine oil leak may develop from the rear of the engine. This is commonly caused by a failed oil pump drive o-ring seal. The leaking o-ring should be replaced to correct this concern.

The heater core may leak coolant which could cause the engine to overheat and steam to fog up the inside of the windshield.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

Acid may leak from the battery at the cable connections, resulting in corrosion on the battery cable ends and in the battery tray. A Leaking battery should be replaced and the cables thoroughly cleaned or replaced if necessary.

Front brake rotors can wear causing a pulsation felt in the brake pedal. Our technicians often recommend replacement of the front rotors and brake pads as the best option to correct this condition.

A coolant leak may develop from the water pump. The engine may overheat as a result of the coolant loss. A leaking water pump should be replaced.

The engine may start and stall with the security light flashing. This is commonly caused by a failed passlock sensor which is part of the ignition lock cylinder. A secondary cause could be the ignition switch itself. Worn contacts inside the ignition switch can cause voltage drop issues which can affect the passlock system. Proper diagnoses should be performed before replacing any parts.

An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.

The transmission console shifter or wiring may fail causing the key to become stuck in the ignition.

The high pressure power steering hose will commonly leak fluid; it should be replaced.

The front struts may show signs of wear, or be excessively bouncy ride at freeway speeds. This may begin to occur at around 75,000 miles.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.