Oldsmobile Bravada Problem Reports

RepairPal Verified Oldsmobile Bravada Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

The engine may develop a misfire due to worn valve seats. This fault will cause the Check Engine Light to illuminate. Replacement of the cylinder head may be required to correct this concern.

On vehicles equipped with rear air springs, the air compressor may fail causing the rear suspension to sit low.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The distributor may develop internal faults. This can cause a rough running engine or stalling condition, the Check Engine Light may or may not illuminate. Our technicians tell us that the distributor should be overhauled or replaced to correct this concern.

The cooling fan clutch may fail causing excessive fan noise and/or the Check Engine Light to illuminate.

The cooling fan clutch may fail causing excessive fan noise and/or the Check Engine Light to illuminate.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

The EGR valve may stick open causing a rough idle and the Check Engine Light light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.

The intake manifold gasket may develop and external engine oil or coolant leak. In some cases, an internal coolant leak may occur causing coolant to mix with the engine oil. Running the engine with a coolant/oil mix may result in engine damage. Replacing the intake manifold gasket should correct this issue.

The HVAC blower motor may stop working at one or more speeds due to a faulty blower motor resistor block. Our technicians recommend to confirm the resistor is at fault by first checking the operation of the switch.

A door window may move slowly or stop in mid travel due to a failing power window motor. The affected window may start working again after the motor cools off. Replacing the faulty window motor will commonly correct this concern.

An oil leak may develop from the distributor o-ring seal requiring replacement of the seal.

The electrical contacts in the ignition switch may fail and result in erratic instrument panel gauge operation or illumination of the Check Engine Light. A failed ignition switch will require replacement.

4.3L V6 multi-port FI only
The exhaust gas recirculation valve (EGR) may stick open causing a rough idle and the Check Engine Light to illuminate. Our technicians tell us that a piece of carbon may become stuck in the valve causing this problem. Cleaning the valve will usually correct this condition, in some rare cases the valve will need to be replaced.