Oldsmobile 88 Problem Reports

Newest Oldsmobile 88 Problem Reports

Report A Problem

The mass air flow or crankshaft position sensor may fail causing the engine to stall intermittently. Proper diagnoses will be necessary to determine the cause of any stalling condition.

The steering rack may fail causing a loss of power steering fluid as a result the steering may become hard to turn.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

A Loose or worn gas cap may cause Check Engine Light to illuminate.

The outer tie rod ends on the steering linkage may wear causing excessive free play in the steering and uneven tire wear. If the worn tie rod ends are replaced, the wheel alignment should be checked and adjusted as necessary.

The intake manifold gasket can develop external engine oil leaks. The intake manifold will need to be removed and the gaskets replaced to correct this issue.

The EGR tube may develop an engine vacuum leak causing the engine to run lean. The Check Engine Engine may or may not illuminate.

The cam sensor interrupter (magnet) may become demagnetized and/or fall off of the camshaft gear causing the Check Engine Light (Service Engine Soon) light to illuminate. On higher mileage vehicles it would be advisable to replace the timing chain and gears if this problem were to occur as the timing cover must be removed to replace the interrupter.

The upper intake manifold may develop an internal coolant leak causing one or more cylinders to fill with coolant. This can cause the engine to "hydro-lock" and not turn over. Removing the spark plugs will allow the engine to turn over pushing the coolant out of the spark plug holes. Replacing the upper intake plenum and gasket is commonly required to correct this condition.

The engine can be very difficult to start after this problem has been repaired, it can be helpful to clear as much of the coolant from the intake manifold and cylinders as possible before reassembling the intake manifold.

One or more heater & AC (HVAC) temperature and/or air delivery mode door actuator may fail, resulting in improper temperature or air delivery. If this occurs, fault code(s) should be stored in the HVAC control module which should assist in diagnoses.

The transmission pressure control solenoid may fail causing erratic shifting. Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid.

The water pump may develop a coolant leak resulting in an engine overheating condition.

An automatic transmission fluid leak may develop from the rubber section of a transmission cooler line. In some cases the rubber section of hose can be replaced. In others, the complete cooler line must be replaced to correct this type of leak.

Problems with anti-theft systems using the raised-chip key can prevent the car from starting. The wires in the steering column to the ignition lock cylinder tend to break. The key and ignition lock cylinder should be replaced to correct this condition.