The engine may stall at times due to a failed crankshaft position sensor and/or camshaft position sensor, These sensors can fail intermittently as they warm with the engine. Sensors on certain models have been recalled by Nissan and will be replaced as necessary. Please visit our recall section for this model to see if your vehicle is covered by this recall.
Nissan Sentra Problem Reports
Newest Nissan Sentra Problem Reports
The EGR Valve can malfunction causing a hesitation when accelerating, rough idle, or idle hunting (surging or idle going up-and-down). If the valve malfunctions, there may or may not be a Check Engine light.
Crankshaft and camshaft position sensors can leak oil into the connector causing Check Engine Light illumination. The engine may also stall as a result. Leaking sensors should be replaced. Certain 2000-2003 models were recalled for a separate camshaft and crankshaft sensor issue. For more information on the recall please click here»
If the vehicle is hard to start after setting overnight, the problem could be the fuel pressure regulator has failed and is allowing the fuel pressure to bleed off. A failed fuel pressure regulator will should be replaced.
Nissan issued a recall on the fuel pump for premature failure. There was an owner notification program and labels were placed on the fuel pump access panel and next to the AC charge label in the engine compartment.
Screws inside the intake manifold can become loose causing internal engine damage if they fall out completely. Our technicians report that using a strong thread locker on the power valve butterfly screws can help prevent them from becoming loose.
The catalytic converter closest to the cylinder head can fail causing illumination of the Check Engine Light. Prompt repair of this problem is recommended because the catalyst material can be sucked into the engine and cause internal damage.
Some Nissans with the 2.5 have multiple ignition coil failures.
The reason is the negative battery cable is corroded at the mounting at the bell housing on the transmission.
the solution is to replace the entire negative cable with a factory upgraded cable and replace the coils as well.
Excessive timing chain noise, a rattling or ticking, on higher mileage cars may lead to timing chain failure, which can cause engine damage. There are upgraded chain tension guides with a steel backing to improve durability and a modified repair procedure no longer requires the removal of the cylinder head to replace the timing chain. Maintaining proper engine oil level and frequent oil changes are important to ensure the long-term durability of this engine.
A weak battery or low battery voltage can cause the transmission to enter into fail safe mode. This will cause a loss of power because the transmission will be locked in third gear.
A growling noise may be noted from the manual transmission. This is commonly caused by a failing front bearing. Disassembly of the transmission will be required to replace the failed bearing.
It is not uncommon for rust to develop in the area of the fuel filler door.