Nissan Pathfinder Problem Reports

RepairPal Verified Nissan Pathfinder Problem Reports

Report A Problem
View:Most ReportedNewestRepairPal Verified

Problems with the ignition coil can cause poor engine performance due to misfires. This may cause the Check Engine Light to illuminate. Nissan offers an upgraded ignition coil.

Problems with the ignition coil can cause poor engine performance due to misfires and the symptoms may be intermittent. This may cause the Check Engine Light to illuminate.

The Check Engine Light may illuminate due to a defective charcoal canister vent control valve. The charcoal canister is a component in the Evaporative emissions (EVAP) system.  Our technicians tell us a failed vent valve will require replacement.

The fuel level sensor can fail causing erratic or inaccurate fuel gauge readings. The Check Engine Light may also illuminate. Nissan has recalled 2006 - 2008 vehicles only for this fuel gauge issue. For more information on the recall, please click here»

The Check Engine Light may illuminate because the sensor that monitors the engine's intake valve timing stops working (Intake Valve Timing Control Position Sensor). Replacement of the failed sensor will commonly correct this problem.

A whining or buzzing type noise may develop from the timing chain area caused by excess slack in the secondary timing chains. Nissan has issued a service bulletin (NTB09-128) regarding this issue. Replacement of both secondary timing chains and their tensioner shoes will be necessary to repair this concern. As part of this repair, the engine oil and filter should also be replaced.

The distributor shaft bearing can become rusty, and seize causing the engine to stall or not start. The failed distributor will commonly require replacement.

Screws inside the intake manifold can become loose causing internal engine damage if they fall out completely. Our technicians report that using a strong thread locker on the power valve butterfly screws can help prevent them from becoming loose. The manual transmission models reportedly do not have the intake manifold power valves.

Screws inside the intake manifold can become loose causing internal engine damage if they fall out completely. Our technicians report that using a strong thread locker on the power valve butterfly screws can help prevent them from becoming loose. The manual transmission models reportedly do not have the intake manifold power valves.

The exhaust manifold often warps and cracks, breaking off the studs between the cylinder head and the exhaust manifold. The noise may be most noticeable when the engine is cold.

A problem with the mass air flow sensor can result in poor engine performance or drivability problems. This may cause the car to stall or misfire.

The engine may not crank when the key is turned to "start" if the starter relay fails. This can be confused with a defective starter motor.