Cases have been reported of unexpected airbag deployment. To help ensure proper operation of the airbag system, all cases of airbag warning light illumination should be investigated thoroughly and repairs made as necessary.
Problems for specific Mitsubishi Mirage years:
Car problem reports
Problem with your car? See what our experts say or submit your own.
Newest reported Mitsubishi Mirage problems
There have been reports of airbags not deploying in the event of a frontal impact. Some claim that a shorted airbag wire harness can cause this to occur. Unfortunately there is no diagnoses that will isolate this problem other than fault codes stored in the airbag control module. Our technicians recommend to have any airbag light issues diagnosed and repaired in order to help ensure the airbags will deploy when needed.
The key may become stuck in the ignition as a result of a failed ignition lock cylinder. Replacement of the lock cylinder should correct this condition.
A pulsation may be noted upon brake apply, most commonly caused by warped front brake rotors. Front brake pads may also wear out prematurely. Our technicians recommend replacing worn pads and rotors with quality replacement parts in order to achieve the best possible longevity for the front brake components.
The manual transmission may become difficult to shift, this is commonly caused by binding between the synchronizer and the gear surface. Adding a special friction modifier to the manual transmission fluid will often correct this condition. If the problem persists revised synchronizer kits may be available.
A no start condition may be a result of an internal distributor fault. Our technicians tell us the replacement of the distributor may be necessary to correct this condition.
The front door hinges may fail causing the affected door to sag and become hard to open and close. If this condition occurs replacement of the failed hinges will be necessary to correct this condition.
Intermittent engine stalling may be caused by a fault engine control module (ECM). Our technicians tell us if this is the case the failed ECM will require replacement.
The plastic button on the seat belt buckle may crack and brake apart causing the seat belt to not release and/or buckle properly. If this occurs the affected buckle assembly will require replacement.
The automatic seat belts may not function correctly. Commonly noted as not moving completely to the end of their travel and/or feeling to tight when secured. These conditions should be properly diagnosed the help ensure correct repairs can be completed to restore proper operation.