Mercury Problem Reports

Newest Mercury Problem Reports

Report A Problem

Squeaks and creaks heard while driving over bumps and turning can be caused be a couple common sources and should be carefully diagnosed. Possible weld issues on the lower control arms can cause the noise concerns and require repair kits for the lower control arms from Ford. A jounce bumper (bump stop) rubbing against dry strut plate can cause an abrasion noise from the strut area. In this case the strut assembly should be disassembled to lubricate the jounce bumper and then reinstalled.

Power steering fluid may leak at the power steering pump, line, and/or steering rack. The lines may not be clamped tightly enough, causing a leak. Add new clamps and seals to the power steering line to the pump and to the steering rack.

Failure to change the power steering fluid can cause the fluid to become gray with metal particles. The contaminated fluid can damage the power steering pump resulting in a growling noise when the wheel is turned; the damaged pump will require replacement to eliminate the noise.. Life of the power steering gearbox and pump will be shortened if the fluid is not serviced regularly.

The engine may overheat at idle when the AC is on. A new, upgraded fan motor and resistor may be required to correct this concern.

Worn motor mounts can cause the motor to rise during acceleration, causing a clunking noise and possibly damaging the AC hoses. Damage to the AC hoses can cause a loss refrigerant resulting in no cold air from the AC. The motor mount will need to be replaced prior to repairing the damaged hose or the problem will continue.

The composite (plastic) intake manifold may crack near the thermostat housing and cause a coolant leak. Ford released an updated manifold that was reinforced to prevent a recurrence. No recall was issued for this problem but Ford did extend the warranty to seven years on some models from the date of purchase.

The throttle position sensor (TPS) may fail. Common symptoms of a defective TPS can be rough idle, hard starting, hesitation on acceleration, poor fuel economy, and stalling.

Coolant may start leaking from the coolant reservoir bottle. The coolant reservoir should be replaced.

A coolant leak may develop from the radiator. Ford has released and updated radiator and powertrain control module (PCM) software update to address this issue. The software update includes revised cooling fan operating parameters. Failure to complete both service procedures may result in repeated radiator failures.

The alternator may get too hot, causing premature bearing failure.

The automatic transmission may develop shifting concerns. On lower mileage vehicles, upgrading the software in the powertrain control module (PCM) and the transmission control module (TCM) may correct the problem. As the mileage increases, internal transmission damage can occur. Repairs could involve replacement of the valve body or a complete transmission rebuild. Whenever major transmission repairs are made, it is important to be sure the PCM and the TCM have the latest software updates to help prevent these issues from reoccurring.

The automatic transmission may develop shifting concerns. On lower mileage vehicles, upgrading the software in the powertrain control module (PCM) and the transmission control module (TCM) may correct the problem. As the mileage increases, internal transmission damage can occur. Repairs could involve replacement of the valve body or a complete transmission rebuild. Whenever major transmission repairs are made, it is important to be sure the PCM and the TCM have the latest software updates to help prevent these issues from reoccurring.

A failed heater blend door or actuator can cause the temperature control for the HVAC system to stop working. A clicking sound from the dash area would commonly indicate an actuator fault. If the heater gets stuck on the hottest setting, the heater blend door may be broken requiring replacement of the heater box to repair the issue.

An external Engine oil leak may develop from the distributor O-ring seal. A new O-ring seal will be needed to correct this leak.

The magnet for the camshaft position sensor may fall out of its mount and damage the synchronizers. This causes long crank times when starting the engine and may cause the Check Engine Light to illuminate. If this happens, both the magnets and the synchronizers need to be replaced.