Mercedes-Benz S500 Problem Reports Movement/Vibration while car is running in park at 3000 rpm
Mercedes-Benz S500 Problem Reports
Newest Mercedes-Benz S500 Problem Reports
Front thrust arm and control arm bushings can crack and sometimes tear completely. If this is not repaired quickly, damage to the front subframe unit will occur, which is very expensive to repair. Updated control arms (that prevent damage to the subframe when the bushings wear out) are available.
Right front spring control arm's rubber mount has collapsed and is grinding the front sub-frame. Need to replace control arm (both sides are recommended, along with sub-frame and potentially other parts such as the sealing bellows and supporting joint and strut. I located a Mercedes Technical Support Bulletin #P-B-33.15/12c but Mercedes dealership states that they have no record of any recall or warrantee in this regard and that I would be r...
The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
A faulty mass air flow (MAF) sensor can cause erratic/rough engine operation and fuel economy issues. Since this sensor measures the actual amount of air entering the motor, when it fails, the engine control module (ECM) takes the wrong information and delivers incorrect volumes of fuel to the cylinders.
Ports in the cylinder head related to the emissions air injection and EGR systems can clog; the cylinder head should be removed and the ports cleaned.
A refrigerant leak may develop from one or more of the following AC components: AC compressor, hose manifold for the compressor, or the evaporator core. The loss of refrigerant can cause poor AC performance. Our technicians tell us that proper leak diagnoses should be performed in order to determine the cause of any refrigerant loss.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance.
The center console armrest can break. Replacement is commonly the recommended repair.
Other than a defective motor, a bad switch or blower motor resistor assembly can cause an inoperative heater blower motor.
The lower control arm bushings can wear and crack, resulting excessive movement at the control arm pivot point, leading to irregular and premature tire wear. Worn Ball joints can also cause similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
The head lamp wipers are easily damaged, especially by automatic car washes.
Due to exposure to the sun, lenses for head lights may become opaque (cloudy or hazy). This reduces the effectiveness of the lights. Our technicians tell us plastic polishes can improve the clarity of the lenses, but replacement of the lamp housings is the only way to regain the full intensity of the lights.
Analog Tele Aid units are no longer supported and must be updated to digital, preferably at a dealership or a well-equipped independent shop. The update and all related factors should be completed at the same time.
The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any time.