The mass air flow sensor tends to fail causing poor fuel economy and Check Engine light illumination. The engine air filter should be replaced when the mass air flow sensor is replaced; a dirty filter can allow debris to damage the new sensor.
Car problem reports
Problem with your car? See what our experts say or submit your own.
Repairpal verified Mercedes-Benz E430 4MATIC problems
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
A squeak from the steering column is often related to a rubber boot in the column or a seal in the power steering rack.
Due to wear, high usage vehicles can experience ignition lock and tumbler failures. The ignition lock cylinder will generally require replacement to correct this concern.
The switch for the vanity mirror light above the sun visor fail; there is an updated switch for some models. On the remaining models, due to a redesign, the mirror "cassette" will need replacement.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
The rubber bond in the harmonic balancer can decay, which causes the balancer to move and work its way toward the timing cover. If the balancer comes into contact with the timing cover while the engine is running, it will fracture and damage the cover and potentially other surrounding parts. The harmonic balancer should be inspected at every service.
Brake lamp housings can melt, resulting in a loss of contact for the brake light bulb holder. If this happens, the brake light will not work. Replacement of the damaged lamp housing should correct this problem.
High mileage vehicles may develop a leak from one or more of the transmission oil seals.
Instrument cluster displays tend to fail, especially the clock and gear indicators. Our technicians tell us the instrument cluster will require replacement to correct this issue.