Mercedes-Benz CLK500 Problems
RepairPal has identified the most common problems with the Mercedes-Benz CLK500 based on complaints from actual vehicle owners. We'll tell you what the problem is and what it'll take to fix it.
A repetitive clicking noise from behind the center area of the dash panel is usually caused by a broken stepper motor actuating arm. The actuating arm controls the direction of air flow in the climate control system. Disassembly of the center console will be required to access and change the broken arm with the updated, reinforced part.
The Mercedes Benz CLK500 may have engine oil seeping or leaking from the back of the cylinder heads. This is commonly misdiagnosed as leaking valve covers.
On the back of the cylinder heads there are three, in total, plastic expansion plugs that plug access ports to the camshafts. These plugs are well known for seeping oil, and leaking if left unattended. The oil will run down the back of the engine and eventually make it to the ground.
Replacement of these three plastic plugs is extremely simple, and should be done as regular maintenance. The recommended interval for replacement is every 60,000 miles.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.
The electrical connector at the automatic transmission may leak fluid into the wiring harness. If not repaired, the oil will migrate through the wiring harness and damage the transmission control module. At that point, a new harness and control module may be necessary to correct this problem.
The heating, ventilation and AC (HVAC) heater box is susceptible to mildew buildup. This can result in a musty odor from the HVAC system, most noticeable when the system is first turned on.
The sway bar end link joints may wear and cause a knocking noise over bumps. Loose or warn links should be replaced to correct this type of noise.
A vibration felt through the center floor of the vehicle can be caused by driveshaft flex discs, which crack and shred, causing excessive driveshaft movement. Not repairing these can cause damage to the driveshaft center support bearing, or, in the worst case scenario, damage to the transmission or differential.
An engine Oil leak may develop from the PCV vent housing on the valve cover and/or the inspection plate on the front of the engine.
High mileage or older vehicles commonly develop leaks from the differential seals and/or cover. Our technicians recommend a complete reseal of the differential unit whenever these leaks are repaired.