The evaporator temperature sensor can fail, causing the AC compressor not to cycle. If the AC compressor does not turn on, the AC system will not blow cold air. If the compressor is stuck on, the air will be very cold at first, before warming up.
Mercedes-Benz C230 Problem Reports
RepairPal Verified Mercedes-Benz C230 Problem Reports
A tube for the EGR system tends to clog with carbon buildup.
A refrigerant leak may develop from one or more of the following AC components: AC compressor, hose manifold for the compressor, or the evaporator core. The loss of refrigerant can cause poor AC performance. Our technicians tell us that proper leak diagnoses should be performed in order to determine the cause of any refrigerant loss.
Failed spark plug wires and/or ignition coils can cause intermittent misfires (rough running); the Check Engine Light may also illuminate. Diagnoses of the ignition system will be necessary to determine which components are at fault.
The camshaft adjuster solenoid (which is related to the variable valve timing system) may fail or timing chain/balance shaft components may wear, resulting in illumination of the Check Engine Light and various drivability issues. Mercedes-Benz has released a service bulletin outlining specific repair instructions depending on fault codes stored.
The crankshaft position sensor may fail. Symptoms of this are: The engine will crank—but not start—especially when the engine is warm. The car may start again if it is left to cool off, but it may run roughly or have poor performance. Communicating these specific symptoms to your technician can save diagnostic time.
The interior wood trim and dash pad are likely to crack due to age and sun exposure.
The engine crank case vent hoses may fail, resulting in a rough running engine and/or poor engine performance. Damaged hoses should be replaced.
Valve guides tend to wear in higher mileage cars, which causes compression loss in the engine. This leads to a loss in fuel economy or performance. Replacing the guides, which requires cylinder head removal, may solve the problem or a new cylinder head may be needed.
Oil can leak into the engine wiring harness from the camshaft sensor. If the leaky sensor is not repaired, the oil can migrate through the wires and possibly damage the engine control unit. Have the sensor and harness checked regularly.
Irregular and premature tire wear can be caused by the lower control arm bushings cracking, resulting excessive movement at the control arm pivot point. Ball joints can also wear out prematurely, causing similar tire wear symptoms. I some cases it may be necessary to replace the lower control arm, including bushings & ball joint to correct this concern.
Irregular and premature tire wear can be caused by the front thrust link bushings cracking and causing excessive movement in the suspension. The thrust link bushings are fluid-filled (to help reduce vibration), so if they crack, they will leak oil.
The heating, ventilation and AC (HVAC) heater box is susceptible to mildew buildup. This can result in a musty odor from the HVAC system, most noticeable when the system is first turned on.
The cooling system hoses may fail unexpectedly. The hoses can look good on the outside, but the rubber can degrade and erode on the inside. If not carefully checked, the hoses can burst at any time.